A seesaw pivots as shown in below. What is the net torque about the pivot point?
With explanation please
I GIVE 25 POINTS

The  positive feedback influence the stability of a system is:  It can cause the system to remain stable as long as inputs are constant. Hence, option (A) is correct.

A body's capacity to return to its initial static equilibrium after being slightly shifted is referred to as stability.

A body in equilibrium doesn't suffer linear acceleration or a turning effect, and unless a force from the outside disturbs it, it will stay in that state forever. (The First Law of Newton)

Learn more about stability here:

https://brainly.com/question/1315045

#SPJ2

Answer:c

Explanation:got it wrong bc the other person didn’t know bc their small minded

Answer:

B=the control group

Explanation:

Answer:

B

Explanation:

Answer: 0.67 m/s^2

Explanation:

Bc it is trust me

Answer:

.67 m/s^2

Explanation:

khan academy

Answer:

t = 25 seconds

Explanation:

Given that,

Distance, d = 115 m

Initial speed, u = 4.2 m/s

Final speed, v = 5 m/s

We need to find the time taken in increasing the speed.

We know that,

Acceleration, [tex]a=\dfrac{v-u}{t}[/tex] ....(1)

The third equation of kinematics is as follows :

[tex]v^2-u^2=2ad\\\\\text{Put the value of a in above equation}\\\\v^2-u^2=2\times \dfrac{v-u}{t}\times d\\\\\because (a^2-b^2)=(a-b)(a+b)\\\\(v-u)(v+u)=\dfrac{2\times (v-u)d}{t}\\\\t=\dfrac{2d}{v+u}\\\\\text{Putting all the values}\\\\t=\dfrac{2\times 115}{4.2+5}\\\\t=25\ s[/tex]

Hence, it will take 25 seconds to increase the speed.

Answer:Caloric theory, explanation, widely accepted in the 18th century, of the phenomena of heat and combustion in terms of the flow of a hypothetical weightless fluid known as caloric. ... The idea of an imaginary fluid to represent heat helped explain many but not all aspects of heat phenomena.

Explanation:

please give me brainliest....

Answer:

all outer planets are large

Explanation:

The sun and the planets compose the solar system. The common factor among all the outer planets is that they are large.

The planets constitute an essential part of the solar system. The sun is at the center of the solar system and is surrounded by the planets.

Now the earth is the third planet in the solar system. The outer planets are the planets that are all far from the sun. The common factor among all the outer planets is that they are large.

Learn more about planets: https://brainly.com/question/14581221

Answer:

I think it might be umm... b

The correct answer is actually D

Explanation: i got it right on my district assignment! :)

Answer:

D. A 10 kg rock at 15°C

Explanation:

Thermal energy is heat energy, meaning that the hotter rocks will have more energy.

The heavier/larger rocks can store more energy.

So if we combine the largest two variables, we get a 10kg rock at 15°C.

Answer: D

Explanation:

Answer:

Explanation:

Total distance covered  = 25 + 15 = 40 m

Total time = 15 + 8 = 23 s

Average speed = total distance covered / total time

= 40 / 23

= 1.74 m / s

Total displacement = 25 - 15 = 10 m

Total time = 15 + 8 = 23 s

Average velocity = total displacement / total time

= 10 / 23

= .434 m / s to the right .

The average speed of the student is approximately 1.74 m/s, and the average velocity is approximately -1.74 m/s (to the left).

Given:

Distance to the right = 25 m

Time taken to the right = 15 s

Distance to the left = 15 m

Time is taken to the left = 8.0 s

To calculate the average speed and average velocity, we need to use the following formulas:

Average speed = Total distance traveled ÷ Total time taken

Average velocity = Displacement ÷ Total time taken

Calculate the total distance traveled:

Total distance = Distance to the right + Distance to the left

Total distance = 25 + 15 = 40 m

Calculate the total time taken:

Total time = Time taken to the right + Time taken to the left

Total time = 15 + 8.0 = 23 s

Calculate the average speed:

Average speed = Total distance ÷ Total time

Average speed = 40 ÷ 23 = 1.74 m/s

Calculate the displacement:

Displacement = Final position - Initial position

Displacement = (-15 ) - 25  = -40 m

Calculate the average velocity:

Average velocity = Displacement ÷ Total time

Average velocity = -40 ÷ 23  ≈ -1.74 m/s

So, the average speed of the student is approximately 1.74 m/s, and the average velocity is approximately -1.74 m/s (to the left). The negative sign in the average velocity indicates that the student's net direction is to the left.

To know more about the speed and velocity:

https://brainly.com/question/24909693

#SPJ3

Answer:

good luck

Explanation:

.....................

Answer:

The answer is True

Love, which can’t be observed or measured directly, is an example of a psychological construct.

Explanation:

On edge 2020

The event that causes the least amount of time to go by on the game clock is a free throw.

In conclusion, the event that causes the least amount of time to go by on the game clock is a free throw.

Learn more in:

https://brainly.com/question/1456627

Answer:

A. Potassium

C. Hydrogen

Explanation:

Answer:

576.975 cubic feet of helium will be needed to fully inflate the balloon

Explanation:

To determine how many cubic feet of helium will be needed to fully inflate the balloon, we will determine the volume of the balloon.

From the question,

The balloon is shaped like a giant soda can.

A giant soda can is cylindrical.

Hence, we can determine the volume of the balloon shaped like a giant soda can by using the formula for finding the volume of a cylinder.

The formula for finding the volume of a cylinder is

V = πr²h

Where V is the volume of the cylinder

π is a constant (Take π = 3.14)

r is the radius of the cylinder

and h is the height of the cylinder

From the question, the balloon is 15 feet tall and 7 feet wide

Hence,

Height, h = 15 feet

Width = 7 feet

(NOTE: The width of a cylinder is the same as the diameter)

Then, diameter = 7 feet

Radius, r is given by

Radius = Diameter / 2

Then, Radius = 7 feet / 2 = 3.5 feet

∴ Radius, r = 3.5 feet

Now, for the volume of the balloon,

V = πr²h

V = 3.14 × (3.5)² × 15

V = 3.14 × 12.25 × 15

V = 576.975 cubic feet

This is the volume of the balloon.

Hence, 576.975 cubic feet of helium will be needed to fully inflate the balloon.

Answer:

a

idkdidkdidkdkkdhdksijsnansjnshejdhjsnnebdhhdbsbbshshhsnsjshs

The answer is D, ethical concerns.

Good luck on the Unit Test, fellow edge.nuity user.

Answer:

Derived units are derived from these 7 base units. Derived units are dependent on the base units and are not independent of each other. ... Mass has SI units of kg, distance is measured in m and t has the SI unit of second. Thus, SI unit of force is kg.

Answer:

74km/h

Explanation:

Answer:

103 km/hr

Explanation:

Answer:

If the fan speed increases, then the acceleration increases because a greater fan speed supplies more energy to move the cart.

Explanation:

Edge

Answer:

d) inertia is the tendency of object's to resist changes in its motion

Answer:

It means that 80% of our effort is converted to useful whereas 20% of our effort is wasted to overcome frictional and gravitational force.

Answer:

It means that the total energy produced by the machine is 80 percent and remaining 20 percent is wasted in the term of heat deu to friction.

Hope it is helpful !

Answer:

you need to include the units for both axis to be able to answer this

Explanation:

average speed in uniform motion is the slope anywhere on the line but you could always pick 2 points and do it that way and speed is just rise over run

or y2-y1/x2-x1

Pick two points on the line and determine their coordinates.

Determine the difference in y-coordinates of these two points (rise).

Determine the difference in x-coordinates for these two points (run).

Divide the difference in y-coordinates by the difference in x-coordinates (rise/run or slope).

the second bit i think they are looking for this calculation y = mx + b, where m is the slope and b is the y-intercept (where the line crosses the y axis (the vertical one that has no units

Then use that formula for the last question and put in the x value of 10 and complete the formula to find out what y is

1: About 63% of this electricity generation was from fossil fuels

B: The demand for electricity varies throughout the day. When the demand for electricity is greater than the base load, the National Grid reacts by providing additional electricity. ... Hydroelectric power stations have a very short start-up time and are used to provide additional electricity at peak times.

Answer:

There are following two activities which affect heart rate and respiratory rate.

1-Exercise

2-Hiking

Explanation:

when we are exercising or hiking our heart rate and respiratory rate affected. This is because during hiking and exercising our body may need three or four time your normal cardiac output. This is because our body consuming energy during the workout and our muscles needs more oxygen. To meet the need of energy and oxygen respiration rate become fast and heart rate also increase.

Answer:

p = 3000 kg-m/s.

Explanation:

Given that,

Mass of shark, m = 200 kg

Speed of the shark, v = 15 m/s

We need to find the momentum of the shark. It can be calcullated as follows :

[tex]p=200\ kg\times 15\ m/s\\\\p=3000\ kg-m/s[/tex]

So, the momentum of the shrak is 3000 kg-m/s.

Answer:

Increase in temperature

Increase in pressure

Explanation:

For the rate of collisions to increase, It can happen in various ways

1. The gasses can be made to move faster: This can be done by increasing their temperature. An increase in the temperature of the gases directly relates to a corresponding increase in their kinetic energy. This means that the molecules of the gases can move with a greater velocity, which will increase collision rates.

2. The volume of the container can be reduced: Consider this; If the container is made smaller, the molecules of the gases will have less space to move about. This means that they will be bumping into the walls of the container more frequently. This reduction in volume leads to an increase in the pressure of the gas. This is exactly what happens in a piston-cylinder assembly

The increase in the rate of collisions between gas molecules in a container should result in Increase in temperature and Increase in pressure

1. In the case when the gasses should be quick faster, due to this, the temperature should be increased. In this, the gases molecules should be moved have high velocity

2, Here the container volume should be decreased. Due to this, the volume should be decreased that results in the increment of the gas pressure.

Therefore, The increase in the rate of collisions between gas molecules in a container should result in Increase in temperature and Increase in pressure

Learn more about gases here: https://brainly.com/question/24862829

Answer:

False

Explanation:

Density is a physical property of matter.

Answer:

False

Explanation:

Density is NOT a chemical property, it is a physical property.