Engineering High School

Write the general form of the capacitor voltage for
the electrical network shown in Figure P4.4.
[Section: 4.4] is

Write The General Form Of The Capacitor Voltage Forthe Electrical Network Shown In Figure P4.4.[Section:

Answers

Answer 1

The general form of the capacitor voltage for the electrical network shown is V(t) = 2/50 × e ^ -10t sin (20t)

What is voltage?

Voltage, also known as electric potential difference or electric tension, is a measure of the electric potential energy per unit charge in an electrical circuit. It is the force that drives electric charges through a conductor, and is typically measured in volts (V).

In an electrical circuit, voltage is created by a difference in electric potential between two points, which can be created by a variety of sources such as batteries, generators, or power supplies. The voltage difference between two points in a circuit determines the amount of electrical energy that can be transferred between them, and can be used to power electrical devices such as light bulbs, motors, and electronics.

Learn more about voltage on;

https://brainly.com/question/1176850

#SPJ1

Related Questions

Is James Madison still alive?

Answers

Explanation:

Is James Madison still alive?

no he died

No He died
So James Madison died

The probability that a random variable is greater than or equal to z standard deviations from the mean in a standard normal distribution is p%. What can be said with certainty about the probability that the random variable is less than or equal to –z standard deviations from the mean?
The probability is less than p%.
The probability is equal to p%.
The probability is greater than p%.
The probability is not equal to p%.

Answers

The thing that can be said with certainty about the probability that the random variable is less than or equal to –z standard deviations from the mean is B. The probability is equal than p%.

What is the probability?

The likelihood of a random variable being z standard deviations from the mean or greater is equivalent to P(Z ≥ z) in a standard normal distribution. Statistical software or a z-table can be utilized to determine this probability.

The symmetry characteristic of the normal distribution denotes that P(Z ≤ -z) = P(Z ≥ z), essentially making the distribution symmetric about the mean. Thus, it follows conclusively that the probability of the random variable being less than or equal to negative z standard deviations from the mean is p%.

Learn more about probability on

https://brainly.com/question/24756209

#SPJ1

Answer: B

Explanation:

A one acre lot is 43, 560 sq ft. Draw a lot that is 200' × 220' to represent one acre. This is not exact, but for this project, it will work!

Answers

Answer: 250 ft x 250 ft = 62.500 square feet

an acre is 43,560 sq. ft.

62,500 sq. ft. / 43,560 sq. ft. = 1.4318 acres.

Explanation:

Write me a meme about monetary policy

Answers

Here is a text based meme about Monetary Policy.

What is the explanation for the above response?

"When you try to explain monetary policy to your colleagues, friends and loved ones, and they just look at you like they are lost, guess we'll just have to QE infinity and Beyond!"

This meme concept is based on the topic of Quantitative Easing (QE).

It is to be noted that Quantitative Easing (QE) is a concept that is  utilized by the central banks to trigger positive Reponses int the economy.

Note that it is related to the catch phrase that is popular "to infinity and beyond" form the ToyStory franchise.

Learn more about monetary policy at:

https://brainly.com/question/29694955

#SPJ1

the meaning of the different symbols and abbreviations found on the documents that they use (such as surface finish to be achieved, linear and geometric tolerances, electronic components, weld symbols and profiles, pressure and flow characteristics, torque values, imperial and metric systems of measurement, tolerancing and fixed reference points)

Answers

The meaning of the different symbols and abbreviations found on the documents can be regarded as one that is been used to communicate as well as detailing the characteristics of an engineering drawing.

What are Engineering drawing abbreviations and symbols?

Engineering drawing abbreviations and symbols  can be described as the things that is been used in communicating as well as detailing the characteristics of an engineering drawing.

It should be noted thst these abbreviations are the language that people that  work with engineering drawings  undertand in the manufacturing and inspection of parts and assemblies. Some of the terms  as well as the symbols  which is been recognized world wide are BS8110 or Eurocode 2

Learn more about symbols at:

https://brainly.com/question/29886201

#SPJ1

Other Questions
Iodine is very slightly soluble in water, but its solubility is so low that it is very difficult to see any concentration gradients. Yet it is very esy to determine experimentally that it must be at least slight soluble in water. Why is it so easy? describe the role ""friction"" plays towards creating converging surface winds around low-pressure areas. true or false: a hormone causes the same effect in all of its target cells Which narrative style does Jhumpa Lahiri use in her short story "Once in a Lifetime"?O A.first-person perspectiveO .second-person perspectiveO C.third-person limited perspectiveO D.third-person omniscient perspective The costume of the unidentified ............. suggests the approximate dating of this photo to 1890-1895. a) sitter b) apprentice c) figure d) connoisseur If the myelin sheath was not interrupted by gaps, then the action potential would degrade to nothing and thus the signal would fail to cause neurotransmitter release.Group of answer choicesTrueFalse An admitting order is a medication order that is filled when the patient is:Select one:First accepted into the hospitalLeaving the hospitalIn urgent need of the medicationRenewing a daily medication in the hospital Using production and geological data, the management of an oil company estimates that oil will be pumped from a producing field at a rate given by the following. R(t)=100/t+10+10; 0 leq t leq 15 R(t) is the rate of production (in thousands of barrels per year) t years after pumping begins. Find the area between the graph of R and the t-axis over the interval (6,11) and interpret the results. The areas approximately square units. (Round to the neatest integer as needed.) Choose the correct interpretation of the results below. A. Total production from the end of the first year to the end of the fifteenth year will be approximately 77 thousand barrels. B. Total production from the end of the sixth year to the end of the eleventh year will be approximately 77 thousand barrels. C. It will take approximately 78 years after pumping begins to reach a thousand barrels. D. It will take approximately 77 years after pumping begins to reach a thousand barrels. Measure the lengths of the following segments in inches.A. Length of : __________ in. B. Length of : __________ in. 9. Measure the lengths of the following segments in BOTH centimeters and millimeters. (2 points each) A. Length of : __________ cm Length of : __________ mm B. Length of : __________ cm Length of : __________ mm obc service stands for group of answer choices onboard cargo. over ballast cresting. old benefit connections. onboard computer. onboard courier. In the ocean as a whole, the limiting factor for primary productivity is:a. oxygen.b. light.c. carbon dioxide.d. carbohydrates. If an isotropic material has a Young's modulus of 120 Gpa and a Poisson's ratio of 0.3, calculate its shear modulus. Select one: O G = 39 Gpa G = 29 Gpa O G = 46 Gpa G = 77 Gpa G = 25 Gpa prove the identity. 1 tanh(x) 1 tanh(x) = e2x Marketing planning is part of a broader concept known as:A)Business strategy B)Business planning C)Strategic planning D)Tactical planning E)Mission marketing I need help with this ? Liquefaction is most likely to occur in which type of area? A.the coast of Texas B.a desert in CaliforniaC.hills in FloridaD.the coast of California A recent report from the Pew Research Center indicates that even teens think they have a problem being too attached to their phones. A total of 365 teenage girls and 378 teenage boys were surveyed. Of the teenage girls surveyed, 171 reported feeling too attached to their phone. Of the teenage boys surveyed, 132 reported feeling too attached to their phone. Is there convincing statistical evidence of a difference between the two population proportions at the significance level of 0.01?A) Yes, because the sample proportions are different.B) Yes, because the p-value is less than 0.01.C) Yes, because the p-value is greater than 0.01.D) No, because the p-value is less than 0.01.E) No, because p-value is greater than 0.01. Where does root 20 lie on the number line The population, in millions, of a city t years after 1990 is given by the equation P(t) = 2.9 + 0.08t. In this function Use the Euclidean Algorithm to find the GCD of the following pairs of integers:(a) (1, 5)(b) (100, 101)(c) (123, 277)(d) (1529, 14038)(e) (1529, 14039)(f) (11111, 111111)