Which of the following statements is true about atomic spectra? I. The line spectra of elements are evidence that electron energies are quantized II. Energy is emitted from atoms as they move from lower energy levels to higher energy levels III. Energy is emitted from atoms as they move from higher energy levels to lower energy levels IV. Neutral atoms in the ground state emit light spontaneously

Answer:

Explanation:

Taking into account the definition of Avogadro's Number, the correct answers are:

1 mole of any element contains 6.023×10²³ atoms

1 mole of any compound contains 6.023×10²³ molecules

You have to know that Avogadro's Number or Avogadro's Constant is called the number of particles that make up a substance (usually atoms or molecules) and that can be found in the amount of one mole of said substance. Its value is 6.023×10²³ particles per mole.

Avogadro's number represents a quantity without an associated physical dimension, so it is considered a pure number that allows describing a physical characteristic without an explicit dimension or unit of expression.

Avogadro's number applies to any substance, because the number of elementary units in a mole of a substance is, by definition, a  constant that does not depend on the material or the type of particle considered.

So, in this case, the correct answers are:

1 mole of any element contains 6.023×10²³ atoms

1 mole of any compound contains 6.023×10²³ molecules

hope that help you mark me as brinilylist pls

Answer:

d. Methanol is more acidic than the alkyne and will be deprotonated instead.

Explanation:

because acidity is the ability to lose H+, leaving an anion behind; acidity depends on the stability of the anion.

Answer:

Quadrilateral because there is no parallel and equal

Answer:

10 kg of water was added to the 20 kg of seawater to dilute it from 3% to 2%. Hope this helps!!!!!!

The mole ratio can be seen below and the volume of each precipitate is 60 mL.

A mole ratio refers to a conversion factor that compares the quantities of two chemicals in moles in a chemical laboratory experiment.

Mole ratio For 1:

Mole ratio For 2:

Mole ratio For 3:

Mole ratio For 4:

Mole ratio For 5:

Mole ratio For 6:

Mole ratio For 7:

Since the parameters from the left side of the diagram are not shown, we will assume that the volumes for each precipitate are the addition of both volumes in each column.

By doing so, we have:

1.

2.

3.

4.

5.

6.

7.

Learn more about mole ratio here:

https://brainly.com/question/19099163

Explanation:

Because the place on the map can be changed to another shape by natural effects like faulting,folding , volcanism

Answer:

Maps must change over time as the geographical structures change from time o time. The roads and highways also change often due to the development activities .

Answer:  

e=hf conversion

hope it helps! stay safe as always!

Answer:

Nomenclature is the process of naming chemical compounds with different names so that they can be easily identified as separate chemicals. Inorganic compounds are compounds that do not deal with the formation of carbohydrates, or simply all other compounds that do not fit into the description of an organic compound.

Explanation:

Answer:

The atomic numbers of four elements A, B, C, and D are 6,8,10, and 12 respectively. The two elements which can react to form ionic bonds (or ionic compounds) are B (8= 2,6) and D (12 =2,8,2). So D donates its two electrons to B to fulfill their octet.

Explanation:

Answer:

distance traveled per unit of time.

Answer:

b a c a b

Explanation:

Answer:

15 L

Explanation:

The important thing to remember about reactions that involve gases kept under the same conditions for pressure and temperature is that the mole ratios that exist between the gases are equivalent to volume ratios.

This can be proven using the ideal gas law equation for two gases kept at a temperature

T

and a pressure

P

.

P

⋅

V

1

=

n

1

⋅

R

⋅

T

→

the ideal gas law equation for the first gas

P

⋅

V

2

=

n

2

⋅

R

⋅

T

→

the ideal gas law equation for the second gas

Divided these two equations to get

P

⋅

V

1

P

⋅

V

2

=

n

1

⋅

R

⋅

T

n

2

⋅

R

⋅

T

This means that you have

n

1

n

2

=

V

1

V

2

→

the mole ratio is equivalent to the volume ratio

In your case, the balanced chemical equation looks like this

N

2(g]

+

3

H

2(g]

→

2

NH

3(g]

The problem tells you that this reaction takes place at constant temperature and pressure. You don't need to know the exact values, you just need to know that they are constant for all three chemical species.

You can thus say that since you have a

1

:

3

mole ratio between nitrogen gas and oxygen gas, you will also have a

1

:

3

the volume ratio between these two gases

n

N

2

n

H

2

=

V

N

2

V

H

2

=

1

3

The volume of hydrogen gas needed to react with that much nitrogen gas will thus be

5.0

L N

2

⋅

3

L H

2

1

L N

2

=

15 L H

2

Answer:

We have the atoms, and we have the molar mass of Vanadium (listed in the periodic table) which should be 50.94g/mol.

The first step is to convert the 4.18 x 10^23 atoms into moles by dividing the atoms by Avogadro's number (6.02 x 10^23)  

(4.18 x 10^23)/(6.02 x 10^23) = 0.694 moles

Now we know that moles is equal to the mass divided by the molar mass. So now that we have the moles and the molar mass of Vanadium, we can rearrange the equation to find mass. Once you have rearranged it, you have to multiply the moles by the molar mass.

So 0.694 moles x 50.94g/mol = 35.35g of V

Answer:

Explanation:  encourage your legislators to support land acquisition programs such as Florida Forever and the Rural and Family Lands Protection Program.

Answer:

SORRY IM LATE! at least i saw it.

Explanation:

Kingdom is Eucaryota

domain is eucarya

Atom information–

Substituting values –

[tex]\qquad[/tex] [tex]\twoheadrightarrow\bf A=p^{+}+n^{0}[/tex]

[tex]\qquad[/tex] [tex]\twoheadrightarrow\bf A=26+29[/tex]

[tex]\qquad[/tex] [tex]\twoheadrightarrow\bf A=55[/tex]

____________________________________________

Using the Rydberg formula, the spectral line of H - atom is suitable for this purpose is Paschen, ∞ → 3.

1/λ = RH(1/nf^2 - 1/ni^2)

Given that;

λ = wavelength

RH = Rydberg constant

nf = final state

ni = initial state

Then;

1/λ =  1 × 10^7 m-1 (1/3^2 - 1/ ∞^2)

1/λ =  1 × 10^7 m-1 (1/3^2 )

λ = 900 nm

Hence, the correct answer is Paschen, ∞ → 3

Learn more about the Rydberg formula; https://brainly.com/question/17753747

The amount of oxygen involved in the reaction would be 20.7 g

The equation of rusting of iron is as follows:

[tex]4Fe + 3O_2 ---> 2Fe_2O_3[/tex]

The mole ratio of Fe to O2 is 4:3.

Mole of 48.3 g Fe = mass/molar mass

                               = 48.3/56

                                = 0.8625 moles

Equivalent mole of O2 = 0.8625 x 3/4

                                       = 0.6469 moles

Mass of 0.6469 moles O2 = mole x molar mass

                                             = 0.6469 x 32

                                              = 20.7 g

More on stoichiometric calculations can be found here: https://brainly.com/question/8062886?referrer=searchResults

Answer:

Q1= 9.42

Q2= 227 KJ

Q3= 31.4 KJ

Qt=269 KJ

Explanation:

First you have to find the heat needed to make ice at a temperature of -45 C to pass to a temperature of 0 C.

You're given the formula so all you have to do is replace by the data you're given (remember to make the Celsius, Kelvin by adding 273.15 to the Celsius since the magnitudes of temperature they're giving you in the constants are the Kelvin)

Q1= (2.093 J/gxK)(100 g)(45 K)

Q1=9418.5 J

Q1=9.4185 KJ≈9.42 Kj(you're asked to give your answer in KJ)

You know have to find the energy needed to liquify the ice, in other words you need to use the enthalpy of fusion to determine the energy that's being used, and since you have 100 grams of water, you only need to find the number of moles present in 100 grams of water by dividing the number of grams by the molar mass of water (18 g/mol) and then replace in the equation.

Q2=(5.56 mol)(40.7 KJ/mol)

Q2=227 KJ

You know have to find the energy needed to raise the temperature of water from 0 C to 75 C. You do the same thing as you did in the first step:

Q3=(4.184 J/gxK)(100 g/)(75K)

Q3=31380 J

Q3=31.38 KJ≈31.4 KJ

For the final step, you only add the Qs of each step:

9.42KJ+227KJ+31.4KJ= 267.82 KJ ≈ 267.8 KJ

Why do you use these procedures?

Well, you could simply have made a unique equation at first sight that involved the changes of temperature from -45 C to 75 C, but you have a phase change in the middle. Phase change keep temperature constant but they require heat from the surroundings in order to, in the case of ice, break the bonds that keep the molecules tight together.

This heat required from the surroundings is the Enthalpy of phase change, in this case enthalpy of fusion.

Answer:

Nomenclature is the process of naming chemical compounds with different names so that they can be easily identified as separate chemicals. ... For example, organic compounds include molecules with carbon rings and/or chains with hydrogen atoms (see picture below).01-Jul-2014

Nomenclature: Iron (II) Chloride

Compound: FeCl2

Answer:

Amerigo Vespucci, was the first European to reach the Caribbean Islands.

Please select the best answer from the choices provided

T

F

Explanation:

Answer:

B. wave 1 has a larger wavelength than wave 2

Wave 1 has larger wavelength than wave 2. Hence, option B is correct.

Wavelength is defined as "the difference between two successive crests and troughs of the wave. The wavelength described the how long wave is. It is measure in the direction of wave.

Wavelength is usually denoted by the Greek letter ( λ ).

Wavelength is equal to the speed ( V ) of wave train to divided by frequency ( F ). It is given as,

λ = V ÷ F

Here,

λ = wavelength

V = speed

F = frequency

The distance between one crests (top) to another crests is a Wavelength. Alternately the distance between one troughs (bottom) to another troughs is wavelength.

The distance between two  crests in wave 1  is more comparatively wave 2 so , wave 1 will have larger wavelength than wave 2.

Therefore, wavelength is used for measuring the radiation.

To learn more about wavelength follow the link;

https://brainly.com/question/12924624

#SPJ2

Answer:

Polythene has the lowest melting/boiling point from all the other covalent structures mentioned in this question.

Answer:

Polythene (polyethene according the IUPAC nomenclature.)

Explanation:

Consider the structure of each option:

Melting each structure requires overcoming the forces that hold the structure rigid:

Van der Waal forces are much easier to break than covalent bonds.

Hence, the melting point of polythene would be the lowest among the options.

The molecular formula of the ethylene glycol is C₂H₆O₂.

From the question given above, the following data were obtained:

Molecular formula = empirical × n = molar mass

[CH₃O]n = 62

[12 + (3×1) + 16]n = 62

31n = 62

Divide both side by 31

n = 62 / 31

n = 2

Molecular formula = [CH₃O]n

Molecular formula = [CH₃O]₂

Molecular formula = C₂H₆O₂

Learn more about empirical and molecular formula: https://brainly.com/question/25820990

Answer:

A chemical equation is the symbolic representation of a chemical reaction in the form of symbols and formula. (i) It must refer to an actual chemical reaction. (ii) It should be molecular. For example, H, O, N should be written as H2, O2, N2. (iii) It should be balanced and conform to the law of conservation of matter.A chemical equation conveys both qualitative and quantitative information. Qualitatively, a chemical equation tells the names of the various reactants and the products.

Answer:

Ranked from lowest to highest:

Sulfur - 999.6 kJ/mol

Hydrogen - 13.5984 kJ/mol

Oxygen - 13.6181 kJ/mol

Fluorine - 17.4228 kJ/mol