Which element has the greatest average atomic mass? iodine bromine tellurium krypton

Humidity refers to the amount of water vapor in the air accurately describes it.

This can be defined as the gaseous phase of water as a result of heating in the atmosphere.

The amount of the water vapor in air is what is referred to as humidity which makes option D the most appropriate choice.

Read more about Humidity here https://brainly.com/question/5369085

Answer:

1) higher

2) lower

1) energy

Explanation:

hope this helps you.

I would really like a brainliest :D

thank you and have a nice day.

Answer:

1) higher

2) lower

1) energy

Explanation:

Answer:

72.22 g

Explanation:

975 mL Mercury× 13.5 g/mL = 72.22 g

Answer:

C. 7.020 x 10^2 g

Explanation:

To convert to scientific notation, move the decimal until there is only one digit greater than 1 and less than 10 before the decimal. In this case, the 7. (Depending on the conversion, you will either move the decimal to the left or right. In this question, you will need to move it left. When you move the decimal left, you inherently think you are moving it in the negative direction, but your final answer will be a positive exponent. The opposite is true for movement in the right direction, leaving a negative exponent in your final answer.)

Then, count the number of places that you moved the decimal from the original number (in this case, you moved it 2 decimal places to the left).

Because you moved the decimal 2 places to the left (-), when you write it in scientific notation, you want to annotate the exponent as the opposite, (+), so that you do not lose the equivalence of the original number (in this case, state it as 10^2 as in choice C).  

Note: Once you do your conversion, you can plug it into your calculator and press "=" to verify that you did not change the number in doing your conversion.

Taking into account the definition of Scientific notation, the correct representation of 702.0 g in scientific notation is option C. 7.020×10² g.

First of all, scientific notation is a quick way to represent a number using powers of base 10. This notation is used to be able to express very large or very small numbers very easily.

The numbers are written as a product:

a×10ⁿ

where:

In this case, to write the number 702.0 in scientific notation, the following steps are performed:

So, the correct representation of 702.0 g in scientific notation is option C. 7.020×10² g.

Learn more about scientific notation:

The value of mass is 680 g.

It is defined as mass per unit volume.

Given:-

[tex]Density=13.6\ g/cm^{3} \\Volume=50\ mL[/tex]

Calculate mass as follows:-

[tex]Density=Mass/Volume\\13.6\ g/cm^{3} = Mass/50.0\ mL\\Mass=13.6\ g/cm^{3} \times50.0\ mL[/tex]

Relationship used:-

[tex]1\ cm^{3} =1\ mL[/tex]

[tex]Mass=680\ g[/tex]

To know more about:-

brainly.com/question/25038476

Answer:

2

Explanation:

Oxygen has 6 electrons in its valence shell.  Since an atom can have a maximum of 8 electrons in the valence shell, oxygen has 2 empty spots in its valence.  This means that oxygen can make 2 single covalent bonds.

The maximum number of covalent bonds that an oxygen atom with atomic number 8 can make with hydrogen is: 2.

Valency can be defined as a measure of the combining power of a chemical element with other atoms to form a molecule or chemical compound.  Typically, valency is measured by the amount of hydrogen atoms that a chemical element can combine with or displace to form a molecule or chemical compound.

Valence electrons can be defined as the number of electrons present in the outermost shell of an atom. Valence electrons are used to determine whether an atom or group of elements found in a periodic table can bond with others.

From the periodic table, we know that an oxygen atom has an atomic number of eight (8). Thus, oxygen has six (6) electrons in its valence shell and two (2) empty shells to form a covalent bond with hydrogen.  

Generally, the maximum number of electrons an atom can hold in its valence shell is eight (8) and since oxygen has has six (6) electrons in its valence shell; it ultimately implies that the maximum number of covalent bonds that an oxygen atom with atomic number of eight (8) can make with hydrogen is two (2) covalent bonds.

Find more information: https://brainly.com/question/18214726  

Answer:

D

Explanation:

because it's saying the diet soda has more calories then regular soda it's like someone claimed you of doing something you didn't do and they don't know that

Answer:

Different ions of different elements (usually metals) make a flame burn with a characteristic color when introduced into the reaction zone; the different colors are caused by the different quantized energy levels of the electrons in the different atoms.

Answer:

0.24%

Explanation:

The following data were obtained from the question:

Measured value = 42.1 g

Actual value = 42 g

Percentage error =?

Percentage error can be obtained by using the following formula:

Percentage error = |Measured value – Actual value | / Actual value × 100

With the above formula, we can obtain the percentage error as follow:

Measured value = 42.1 g

Actual value = 42 g

Percentage error =?

Percentage error = |42.1 – 42| / 42 × 100

Percentage error = 0.1/42 × 100

Percentage error = 10/42

Percentage error = 0.24%

Therefore, the percentage error is 0.24%

Answer:

See explanation

Explanation:

A salt is made up of homogeneous particles while sand is made up of heterogeneous particles. Salt is a crystalline substance while sand is a coarse substance.

If salt and sand are mixed with water, salt forms a solution with water, hence, salt cannot be caught on filter paper. However, sand does not form any chemical specie with water hence it is caught on the filter paper as a solid.

Answer:  The size, mass, and arrangement of atoms affect the density of a substance. How might these factors work together to cause a substance to have a high density? A substance with smaller more massive atoms that are close together is going to have a higher density.

Explanation:

Answer:

[See Below]

Explanation:

✦ A beaker of liquid would measure the volume of a liquid.

✦ A graduated cylinder is good for estimating the volume of a liquid.

✦ You'd most likely use a tape measure to measure the wall length and width.

~Hope this helps Mate. If you need anything feel free to message me.

Answer:

3.8

Explanation:

Answer:

Explanation:

The density of a substance can be found by using the formula

[tex]Density = \frac{mass}{volume} [/tex]

From the question

mass = 6.356 g

volume = 2.56 cm³

Substitute the values into the above formula and solve.

That's

[tex]Density = \frac{6.356}{2.56} \\ = 2.4828125[/tex]

We have the final answer as

Density = 2.48 g/cm³

Hope this helps you

Answer:

1.45 kg

Explanation:

common sense ok

Answer:

1450 grams are in 1.45 kilograms

Answer:

homogeneous mixture

Answer:

True

Explanation:

I guessed XD But I also used Google and that's what I got

Answer:

Never pour water into acid but acid into water

Explanation:

If water is poured into extremely concentrated acid/bases, the rate of volatility and exothermic reaction is too rapid and might cause a chemical eruption, leading to acid burns.

Safety precautions hence dictate the reverse is practiced.

I believe this is a clear answer.

Answer:

An oleophilic material is an entity which exhibits a higher affinity for oil than other solvents. The non-polar nature and ability to form cluster-like structures called micelles are the characteristic properties of oleophilic materials.

plz give brainlist

hope this helped you

Isotopes of the same element have the same atomic number and different mass numbers. Hence, option C is correct.

Isotopes are defined as chemical species which have the same number of protons but differ in the number of neutrons.

It can also be said that they are the chemical species of the same element which have the same atomic number but have different mass numbers.

For Example, C12 and C14 are the isotopes of carbon elements, which have the same atomic number but a different mass numbers.

Hence, option C is correct.

Learn more about Isotopes here:

https://brainly.com/question/4408975

#SPJ5

Answer:

The reactivity of group 1 elements increases as you go down the group because: the atoms become larger. the outer electron becomes further from the nucleus. the force of attraction between the nucleus and the outer electron decreases.

Explanation:

plz if this helped name me brainliest

Answer:

The inner core is a hot, dense ball of (mostly) iron. It has a radius of about 1,220 kilometers (758 miles). Temperature in the inner core is about 5,200° Celsius (9,392° Fahrenheit). The pressure is nearly 3.6 million atmosphere (atm).

Explanation:

Answer:

Atoms making liquids have less attraction than solids, but more than gases

Explanation:

The attraction between atoms in different molecules in a solid is very strong due to strong intermolecular forces present in a solid. However, such intermolecular forces are weaker in liquids than in solids.

This implies that the solid has higher intermolecular forces of attraction compared to gases and liquids. Based on the negligible degree of intermolecular forces between them, a gas has the weakest intermolecular forces hence the atom has very minimal interaction between them.

Answer:

The elixir of life, also known as elixir of immortality and sometimes equated with the name philosopher's stone, is a potion that supposedly grants the drinker eternal life and/or eternal youth. This elixir was also said to cure all diseases.

Answer:

0.0069

Explanation:

When converting between scientific notation try to remember that moving the decimal place to the left is positve and to the right is negative

Since you are changing from scientific to standard you will need to move to the left from the decimal point, making your answer 0.0069

Answer:

Strontium, as opposed to other elements on the periodic table (with the exception of others in the same group/column i.e., the vertical direction), is a good substitute for Calcium because they are in the same group.

Explanation:

This is because elements of the same group behave similarly and have similar properties. This is due to the fact that elements of the same group (in the vertical direction) have the same number of valence electrons.

Answer: The answer is option B

1,000-2,000

Explanation: