whats the volume of a 2 year old

Answer:

The short steep ramp would be much harder because you will have to work more against gravity.

Explanation:

The long shallow ramp would be easier to take than the short, steep ramp because the person would have to use more force on the short, steep ramp to push the wheelchair against the force of gravity.

An inclined plane or a ramp can be defined as a flat supporting surface tilted at an angle, with one end higher than the other, utilized as an aid for raising or lowering a load.

The inclined plane can be defined as one of the six classical simple machines developed by Renaissance scientists. Inclined planes can be utilized to move heavy loads over vertical obstacles.

Moving a body up an inclined plane needs less force than lifting it straight up, at a cost of an increase in the distance moved. The mechanical advantage, the factor by which the force is decreased, is equal to the ratio of the sloped surface's length to the height it spans.

The inclined plane provides the same amount of work to be done with a smaller force exerted over a greater distance. The angle of friction or the angle of repose can be defined as the maximum angle at which a load can rest motionless on an inclined plane because of the friction without sliding down.

Learn more about Inclined plane, here:

https://brainly.com/question/14983337

#SPJ2

Answer: Magnesium nitrate compound contains one atom for magnesium, two atoms for nitrogen, and six atoms for oxygen.

CREDIT safsaf

Answer:

D10 is answer

Explanation:

Magnetism can result from unpaired electrons in a given ion of an element, depending on the spin states of the electrons and d10 is fully filled

The d 10 is the d shell configurations which is most likely to be the best magnet.

Configurations are defined as the way that parts are joined together to form the computer system. The arrangement of electrons scattered throughout the orbital shells and subshells is depicted by the electron configuration of an atom. Divide the periodic table into pieces to represent the atomic orbitals, the areas where electrons are stored, in order to determine an electron configuration. The s-block is represented by groups one and two, the d-block by groups three through twelve, the p-block by groups thirteen to eighteen, and the f-block by the bottom two rows.

Depending on the spin states of the electrons and whether or not d10 is completely filled, magnetism can emerge from unpaired electrons in a specific ion of an element.

Thus, the d 10 is the d shell configurations which is most likely to be the best magnet.

To learn more about configurations, refer to the link below:

https://brainly.com/question/13410673

#SPJ2

Answer:

The heat and light released by fire comes from the breaking of chemical bonds. ... The mass of each molecule, before burning, exceeds the total mass of its atoms by a tiny amount that is equivalent (through E=mc²) to the total energy of all its atomic bonds.

Explanation:

I hope this helps (:

Answer:

A Desert Climatogram is a graph that shows the temperature and rainfall, for each month in the year, for the Desert.

Explanation:

Answer:

When two substances that are of different temperatures are brought together and there is heat transfer such that the substances come to thermal equilibrium, the effect on the particle motion are as follows

1) The particle motion of the hotter body reduces, because its temperature reduces

2) The particle motion of the colder body increases, because its temperature increases

3) For gases, the volume and or pressure reduces for the hotter body, and if the temperature of the gas falls below the boiling point temperature, the gas will change into liquid

For the colder gas, only the volume and or pressure increases and the temperature rises

4) For liquids, if the temperature of the hotter liquid falls below the melting point, the hotter liquid will become a frozen solid

For the the colder liquid, if the temperature is raised above the boiling point, the liquid changes into gas and the temperature does not rise above the boiling point temperature, until all the cold liquid has evaporated

5) For solids, the vibration of the particles of the hotter substance reduces and the solid becomes more brittle

For the colder body, the rise in temperature causes an increase in vibration of the particles, and if the temperature rises above the melting point, the colder solid will begin to melt

Explanation:

Answer:

The correct answer is 2 Na atoms

Explanation:

To determine the number of sodium atoms produced in this reaction, the reaction described in the question must be written out in an equation and then balanced

2NaN₃ ⇒ 2Na + 3N₂

From the equation above, it can be deduced that the number of sodium atoms produced in the reaction described in the question is 2

Answer:

C) 2 Na atoms

Explanation:

Answer:

increased, 7.5-8.3 atm; decreased, 3.5-4.3 atm; Gay-Lussac's Law

Explanation:

1. The collision of gas molecules, results in the pressure increases.

2. The pressure of the system with an increase in the temperature has been 7.2-8.2 atm.

3. The pressure of the system with a decrease in the temperature has been 3.6-4.1 atm.

4. The relationship between the molecules has been given by Gay-Lussac's Law.

The relationship between the temperature and pressure has been given in the gaseous molecules with the ideal gas equation.

1. The temperature has been directly proportional to the temperature. Thus, with an increase in pressure, there has been an increase in temperature and vice versa.

With the collision of the gas molecules with the wall, there has been the liberation of the energy that increases the temperature. The increase in temperature mediates the increase in pressure.

Thus, with the collision of gas molecules, the pressure increases.

2. The relationship between the pressure and temperature has been given as:

[tex]\dfrac{P1}{T1}=\dfrac{P2}{T2}[/tex]

The initial temperature [tex]T1=300\;\text K[/tex]

Final temperature [tex]T2=400\;\text K[/tex]

Initial pressure, [tex]P1=5.4-6.2\;\text {atm}[/tex]

Final pressure, [tex]P2[/tex]

Substituting the values for calculating P2 as:

[tex]\rm \dfrac{5.4-6.2\;atm}{300\;K}=\dfrac{P2}{400\;K}\\\\\textit P2 = \dfrac{5.4-6.2\;atm}{300\;K}\;\times\;400\;K\\\\\textit{P}2=7.2-8.2\;atm[/tex]

The pressure of the system with an increase in the temperature has been 7.2-8.2 atm.

3. The pressure with the reduction of temperature has been given by :

[tex]\dfrac{P1}{T1}=\dfrac{P2}{T2}[/tex]

The initial temperature [tex]T1=400\;\text K[/tex]

Final temperature [tex]T2=200\;\text K[/tex]

Initial pressure, [tex]P1=7.2-8.2\;\text {atm}[/tex]

Final pressure, [tex]P2[/tex]

Substituting the values for calculating P2 as:

[tex]\rm \dfrac{7.2-8.2\;atm}{400\;K}=\dfrac{P2}{200\;K}\\\\\textit P2 = \dfrac{7.2-8.2\;atm}{400\;K}\;\times\;200\;K\\\\\textit{P}2=3.6-4.1\;atm[/tex]

The pressure of the system with a decrease in the temperature has been 3.6-4.1 atm.

4. The relationship between the molecules has been given by Gay-Lussac's Law. The law states that pressure has been directly proportional to the absolute temperature of the system.

For more information about pressure of gas molecules, refer to the link:

https://brainly.com/question/15863086

Answer:

In the first one in a it is red light in b it is radio waves in c it is infrared radiation and d is UV radiation

Explanation:

The forms of radiation from the pairs listed that have longer wavelength are :

A) Red light

B) Radio waves

C) Infrared radiation

D) UV rays

Red light have a wavelength between 650 to 720 nm while a Blue light has a wavelength of 380nm to 500nm which makes it to produce a high energy  visible light.( HEV ) light. therefore the Red light has a longer wavelength.

The wavelength of a microwave is approximately  30 centimeters to 1 millimeter, which makes it shorter than the wavelength of a radio wave ( shortest wavelength in the electromagnetic spectrum.

Hence we can conclude that The forms of radiation from the pairs listed that have longer wavelength are A) Red light B) Radio waves C) Infrared radiation D) UV rays

Learn more about the electromagnetic spectrum : https://brainly.com/question/4533497

The density of an object = 5 g/ml

Density is a quantity derived from the mass and volume  

Density is the ratio of mass per unit volume  

The unit of density can be expressed in g/cm³ or kg/m³  

Density formula:  

[tex]\large {\boxed {\bold {\rho ~ = ~ \frac {m} {V}}}}[/tex]

ρ = density  

m = mass  

v = volume  

Mass = 50 g

Volume of the object =

[tex]\tt 40-30=10~ml[/tex]

So the density :

[tex]\tt \rho=\dfrac{50}{10}\\\\\rho=\boxed{\bold{5~g/ml}}[/tex]

Answer:

3

Explanation:

Answer:

There are 3 estimated digits.

Explanation:

Answer:

C

Explanation:

Yessir

Answer:

A

Explanation:

more domunit

Answer:

It contains more water vapor than cold air

According to the process of conduction which take place from hot to cold end warm saturated air has more water vapor than cold air.

Conduction is defined as a process as a means of which heat is transferred from the hotter end of the body to it's cooler end.Heat flows spontaneously from a body which is hot to a body which is cold.

In the process of conduction,heat flow is within the body and through itself.In solids the conduction of heat is due to the vibrations and collisions of molecules while in liquids and gases it is due to the random motion of the molecules .

As per the concept of conduction, warm hair has more water vapor than cold air, thus the correct option is that warm, saturated air has  more water vapor than cold air.

Learn more about conduction,here:

https://brainly.com/question/31201773

#SPJ6

Answer:

5.56

Explanation:

Answer:

[tex]the \: nucleus \:[/tex]

Explanation:

[tex]the \: nucleus \: is \: organelle \: that \: controls \\ \:a ll \: cellular \: activities.[/tex]

Answer:

Stars generate energy through nuclear fusion. Here's an easy explanation about how the process works. ... Stars spend most of their lives repetitively compressing two hydrogen atoms into a single helium atom – plus a lot of energy, which is released as light and heat.

Explanation:

1) 3,4-dimethyl hex-1,5-diyne

2) 3,3-diethyl pent-4-yn-1-ene

3) 5-(1'-ethyl-2',3'-dimethyl propane) dec-1,3-diyne

Answer:

it is C

Explanation:

I saw from Google. Hope it helps.

I cant get the full picture

sorry

Answer:

Examples of chemical changes are burning, cooking, rusting, and rotting. Examples of physical changes are boiling, melting, freezing, and shredding. Often, physical changes can be undone, if energy is input.

Explanation:

Answer:

Sabihin mo

Explanation:

salamat shoppe

Answer:

because it has more density than water

Answer:

This is because oil is less dense than water and therefore it floats to the surface.

Answer: A (Half of the chromosome pairs from the original cell

Explanation:

Answer:

Aluminum (Al)

Explanation:

It has 3 electron orbitals and has 3 valence electrons

Answer:

A mixture of a weak acid and its conjugate base is called a buffer solution, or a buffer. Buffer solutions resist a change in pH when small amounts of a strong acid or a strong base are added.

I hope this helps :D

Answer: A

Explanation:

Answer:

A.Seafloor spreading

Explanation:

Answer:

C) Elements that decay have a proton to neutron ratio that is too high or too low.

Explanation:

e2021

Answer:

3. One example of condensation is dew forming on grass or leaves early in the morning when the air is cooled/cooling.

4. This is called freezing. For example, when water turns into ice (a solid) because it freezes.

5. This is called melting. The butter reached its melting point and turned into a liquid.

6. Adding or removing energy causes changes in states of matter. Temperature for example can cause melting and freezing.

7. Water which collects as droplets on a cold surface when humid air is in contact with it.

8. Evaporation/vaporization

9. before- particles are compact

during- particles vibrate

after- the particles move freely

10. condensation because it is going from gas into a liquid

11. Evaporation, I know because when liquid gets heated after a period of time  and it reaches its boiling point, it will begin evaporating.

12. When a solid is heated the particles gain energy and start to vibrate faster and faster. ... Although the particles are still loosely connected they are able to move around. At this point the solid is melting to form a liquid. The particles in the liquid are the same as in the solid but they have more energy.

13. Sublimation is the process of transformation directly from the solid phase to the gaseous phase, without passing through an intermediate liquid phase.

14. freezing because particles are becoming compact and getting slower because of decrease in temperature

15. Examples are mothballs, dry ice, snow in the winter months, freeze-drying (ice crystals in a frozen food bag), air fresheners, and printers that print out high-resolution images.

16. Try and think of it in terms of the molecules. The temperature is such that the molecules are all bound together into a solid. Occasionally a surface molecule picks up enough energy to break it bond,.. a statistical probability ,and drifts away. The overall temperature of the solid is reduced by that event,as temperature is just an average of the energy. A little more heat flows into the material ,from the ambient environment, and another molecule escapes, and so the process continues….. if the concentration of the molecules in the vapour space above the solid, is low the reverse process of molecules condensing onto the surface,and releasing energy back into the solid is low.

Explanation:

sorry it took a little bit, it wouldnt let me copy and paste what i had typed /:

Answer:

Tbh i rlly dont think that many will.  Most may succeed  in doing so. But i mean come on its 2020 anything can happen.

Explanation:

Answer:

yes 100% what reasons r there to not tho

Explanation: