Answer:
answer 2.7
Explanation:
a.2.7g/cm3
What change would you expect on the rate of the SN2 reaction of 1-iodo-2-methylbutane with cyanide ion if the nucleophile concentration is halved and the alkyl halide concentration is doubled
Answer:
The rate of reaction remains the same, no change is observed
Explanation:
Remember that for an SN2 reaction, the rate of reaction depends both on the concentration of the alkyl halide and the concentration of the nucleophile.
Hence we can write; Rate = k [Alkyl halide][NaI]
This implies that if we half the concentration of the nucleophile and double the concentration of the alkyl halide, the rate of reaction just remains the same since the reaction is bimolecular and first order in both alkyl halide and nucleophile
The strength of an acid is affected by the polarity of the bond connected to the acidic hydrogen. The more highly polarized this bond, the more easily the hydrogen is ionized. Electronegative atoms or groups of atoms present in the structure of an acid can act to withdraw electrons and produce additional polarization. Two common groups of acids to which this principle can be applied are oxyacids and carboxylic acids. Arrange the following oxyacids in order of decreasing acid strength. Rank from strongest to weakest acid.
a. HBrO
b. HClO
c. HClO3
d. HClO2
Answer:
Explanation:
Oxyacids are acid containing oxygen; they are also known as acid-alcohol or acid-phenol. As said earlier, the strength of these acids increases with increases in the polarity of these compounds. So, what makes the polarity is as a result of the electronegative substituents attached to it. Halogen family possesses the highest electronegativity in the periodic table, and electronegativity decreases down the group.
The ranking of the oxyacids in order of decreasing acid strength from strongest to weakest acid is:
HClO3 > . HClO2 > HClO > HBrO
please help
Air masses that form over large bodies of water are moist. What process determines the amount of moisture in an air mass?
Answer:
I don't know if this is right but try it. The amount of water vapor in the air is called absolute humidity. The amount of water vapor in the air as compared with the amount of water that the air could hold is called relative humidity. This amount of space in air that can hold water changes depending on the temperature and pressure.
What is the difference in drawing Lewis Dot
Structures for ionic and covalent bonds?
The Lewis Dot Structure for ionic compounds must demonstrate how the electrons are transported to create the ions in the compound. The Lewis Dot Structures of covalent compounds must demonstrate how the electrons are being shared to finish the octets of each atom in the molecule.
What is an ionic compound ?A chemical compound known as an ionic compound is one that contains ions bound together by the electrostatic forces known as ionic bonding. Despite having both positively and negatively charged ions, or cations and anions, the molecule is generally neutral.
The term "ionic bonding" refers to a bond in which the ionic character is greater than the covalent character, i.e., when there is a significant difference in the electronegativity of the two atoms, which makes the bond more polar (ionic) than in a covalent bond, where the electrons are distributed more evenly.
The Lewis structures are not frequently drawn for ionic compounds due to the electrical motion of electrons.
Thus, The Lewis Dot Structure for ionic compounds must demonstrate how the electrons are transported to create the ions in the compound.
To learn more about an ionic compound, follow the link;
https://brainly.com/question/9167977
#SPJ2
18. Which two particle diagrams each represent a sample of one substance? Key O = atom of oxygen = atom of hydrogen 0 = atom of chlorine 8 OO 1 நம் மும் 20 2000 (1) I and III (3) II and IV (2) II and III (4) I and II
Answer:
1 and 11
Explanation:
Answer:1 and 11
Explanation:
Im confused please help :(
1.) When kinetic energy is high, velocity is high.
true or false
2.) When potential energy is high, velocity is at its highest.
true or false
Answer: #1: true
#2: false
Explanation: I’m not 100% sure though!
If a feather and in Marble are dropped at the same time from the same height explain. Which object would hit the floor first based on air resistance?
Answer:
the marble would hit the floor first because the feather would be effected by air resistance
Briefly explain why the bulk temperature of the water remains low (at room temperature)
The purpose for witch something is designed or exists
Answer:
to help
Explanation:
to help
Which is the larger atom S or K
Answer:
I'm pretty sure k
Explanation:
I'm not for sure I'm trying to help
Answer:
Potassium
Explanation:
Atomic size decreases across a Period, from left to right as we face the Table, and INCREASES down a Group, a column of the Periodic Table.
Which of the following representations shows the correct placement of trophic levels?
Secondary Consumers
Primary Consumers
Producers
Which among the given combinations below represent a set of isotopes?
1.40 protons and 40 neutrons
II. 41 protons and 39 neutrons
3.42 neutrons and 48 protons
4 40 protons and 42 neutrons
V. 41 protons and 40 neutrons
A. I, II, III
B. III, IV
C.1, IV and II, V
D. 1, V and II. V
E.1. V
Look for the ones with the same number of protons and different neutrons number
KEEP GETTING THIS WRONG PLZ HELP
Answer:
1 224.24242 kg/ m to the 3rd power
A student conducting a calorimetry investigation determines a negative ∆H. What does the negative value indicate about the reaction?
A. The reaction synthesized a single product.
B. The reaction was exothermic.
C. The reaction absorbed energy.
D. The reaction involved decomposition.
Answer:
a
Explanation:
correct
A student heats 25 mL of water from 20°C to 96°C in a glass beaker. The
model represents the motion of the water molecules during heating.
Explain why some of the water molecules shown in the model have
longer arrows than other water molecules during heating.
Answer:
Because the have acquired energy from the heating process, that is why the start moving faster.
Explanation:
Hello.
In this case, since the initial liquid water molecules have a certain energy content, which makes them move with the relatively medium velocity characteristic in liquid-phase substances, once energy starts being added, it is evidenced that the molecules acquire more energy which is able to make them move faster.
In such a way, since the initial water molecules velocity is marked by a medium range arrows, meaning that the molecules are moving not-so-fast, not-so-slow but the heated water molecules are marked by longer arrows, meaning that they move faster, we infer that such velocity increase is due to the addition of heat due to the heating process from 20 °C to 96 °C (just before boiling).
Regards!
Molecular motion is the action of motion of the molecules or the particles in a specific direction. The molecules start moving faster due to the energy given by the heat.
What are the factors affecting molecular motion?The movement of the molecules or the particles in the system is affected by the temperature and the heat given to the system by the external source.
The initial molecules have relative speed and motion in the system and after the addition of the factors the energy of the motion of the particles gets affected.
When the temperature of the water in the beaker is increased then the average kinetic energy of the molecules also increases and hence the motion of the molecules increases.
The medium ranged arrows depict the average speed of the molecule movement in the medium, while the longer arrows suggest the fast-moving molecules of the water.
Therefore, the heat increases energy and in turn the molecular motion.
Learn more about molecular motion here:
https://brainly.com/question/14240663
What is the first step when using a microscope?
A. Place the microscope slide on the stage
B. Plug the microscope in and turn it on
C. Switch to the low power objective lens
D. Secure the slide to the stage clips
Answer:
I think the answer is B :)
Answer:
the first step is B
Explanation: I'm on this lesson
Why can stars be called element factories?
Answer:
They came from the element factories we call stars. Stars are mostly hydrogen throughout most of their lifespans. They are driven by massive and continuous thermonuclear reactions and gravity. ... This extra heat begins to fuse helium atoms into heavier elements like carbon and oxygen and gives new life to the star.
Explanation:
WHAT IS A NEWTON!! specifically the definition!!!!
Answer:
Explanation:
the SI unit of force. It is equal to the force that would give a mass of one kilogram an acceleration of one meter per second per second, and is equivalent to 100,000 dynes.
7. The image shows the effects of exposing the plants to different color of
lights. The size of the plant was measured and the number of leaves were
counted if they are alive or dead. Size of plants and number of leaves are
Size of Plant
Number of Leaves
Living or Dead?
science or
What’s the answer?
Answer:
An apple, potato, and onion all taste the same if you eat them with your nose plugged
Explanation:
The diagram illustrates photosynthesis. Which best describes what is happening in the area marked X?
Answer:
You forgot to include the diagram use snipping tool to take a picture and upload it
Explanation:
How is the periodic table generally arranged?
Answer:
It is generally arranged by the atomic number
Explanation:
The human eye cannot see anything less than 40 micrometers in size. What is this length in meters?
Answer:
4e-5 is the length in meters
Have a nice day! :)
When ignited, a uranium compound burns with a green flame. The wavelength of the light given off by this flame is greater than that of _____.
Answer:
Ultraviolet light.
Explanation:
Uranium is a natural radioactive chemical element with the chemical symbol "U" and an atomic number of 92. Uranium is used for generating nuclear fuels which are typically used in powering atomic bombs and nuclear reactors in the field of electricity generation.
When ignited, a uranium compound burns with a green flame. The wavelength of the light given off by this flame is greater than that of ultraviolet light which typically ranges from 100nm to 400nm. Where, nm is represents nanometer.
Basically, when ignited, a uranium compound burns with a green flame having a wavelength of 4.30 x 10^-7m to 5 x 10^-7m.
Which statement best describes how to predict the formula of a stable ionic compound? Use the same number of cations as anions so that the compound is neutral. Use more cations than anions so that the compound is positively charged. Use enough cations and anions so that the total charge is zero. Use fewer cations than anions so that the compound is negatively charged.
IT's C
Answer:
Option C: Use enough cations and anions so that the total charge is zero
Explanation:
In a stable ionic compound, to get a predict the formula, the positive and negative ions on one side need to cancel out so that the compound becomes neutral.
For example, let's take consider an ionic compound known as Potassium Chloride. It has a formula KCl. Now , breaking it down, the charges will be; K+ and Cl-. This means Potassium (K) has +1 charges and Chloride has -1 charges. Thus, they will cancel out to give a total neutral charge of 0.
Thus, the correct answer is to use enough a ions and cations so that the total charge is zero.
Answer:
C
Explanation:
edge 2020 unit rev
An aqueous solution is in equilibrium with a gaseous mixture containing an equal number of moles of helium, carbon dioxide, and nitrogen. Rank the relative concentrations of each gas in the aqueous solution from highest to lowest. An aqueous solution is in equilibrium with a gaseous mixture containing an equal number of moles of helium, carbon dioxide, and nitrogen. Rank the relative concentrations of each gas in the aqueous solution from highest to lowest.
[CO2][CO2] > [He][He] > [N2][N2] [N2][N2] > [CO2][CO2] > [He][He] [CO2][CO2] > [N2][N2] > [He][He] [He][He] > [N2][N2] > [CO2][CO2]
Answer:
[CO2] > [N2] > [He]
Explanation:
The relative concentration of CO2, N2 and He depends on the solubility of each gas in water. The more soluble in water a gas is, the greater its concentration in aqueous solution.
Among the gases listed, CO2 is most soluble in water hence it is expected to have the greatest concentration in solution followed by N2. Helium gas is insoluble in water hence it has the least concentration in the aqueous solution.
When two or more different elements unite chemically, they form a
A) compound
B) mixture
C) metalloid
D) solution
Answer:
compound ahhhhhhhhhhhhhgh
Which pair of elements are most likely to form a molecular compound?
Nitrogen and Hydrogen
Calcium and Copper
Chlorine and Neon
Please help! I will mark brainliest if correct!
Answer: Two nonmetals.
Explanation:
Answer:The only pair of nonmetals is sulfur and fluorine.
Explanation:The pair of elements most likely to form a molecular compound with each other are two nonmetals.
Please answer 3 and 2
Answer:
3 is c but im unable to see the 2nd questions picture
Explanation:
C2H6O
Percent Composition with work shown
Answer:
50 percent
Explanation:
percentage
will mark brainliest, please hurry! :>
When a hydroxyl group is substituted for a hydrogen atom in a hydrocarbon, what type of molecule results?
a.
an alcohol
c.
a carboxylic acid
b.
an amine
d.
a polymer
Answer:
ans. will be a. an alcohol