the pulley is a uniform disk with a mass of 0.75 kg and a radius of 6.5
on between the 5.8 kg mass and the horizontal surface is 0.25, and the
The system is released from rest. Use work-energy principles to deter
2.8 kg mass and (b) the pulley after the 5.8 kg mass has moved 2.2 m

Answer:Acidic: meat, poultry, fish, dairy, eggs, grains, alcohol. Neutral: natural fats, starches, and sugars. Alkaline: fruits, nuts, legumes, and vegetables.

Explanation:

Answer: When a liquid substance is poured into a vessel, it takes the shape of the vessel, and, as long as the substance stays in the liquid state, it will remain inside the vessel. Furthermore, when a liquid is poured from one vessel to another, it retains its volume (as long as there is no vaporization or change in temperature) but not its shape.

Explanation: A solid has a definite shape and volume. A liquid has a definite volume, but takes the shape of its container. A gas lacks either a defined shape or volume. Plasma is similar to a gas in that its particles are very far apart, but a gas is electrically neutral and plasma has a charge.

Answer:

B

Explanation:

Liquid

Answer:

i'm sorry i'm not a physics student

Answer:

No it's not true electric grow from Positive terminal to negative terminal

Answer:

Explanation:

I just did the Gizmo and the correct answer is 12 :) Hope this helps!

The total resistance of the circuit for parallel resistors of 41 Ω and 17 Ω is 12Ω. Hence option D is correct.

When two or more resistors are connected between two same points, they are said to be connected in parallel combination(as shown in fig).  The equivalent resistance is the reciprocal and the sum of reciprocals of all resistance connected in parallel combination.

[tex]\frac{1}{R_{s}} = \frac{1}{R_{1}} + \frac{1}{R_{2} } + \frac{1}{R_{3}} ..........+ \frac{1}{R_{n} }[/tex]  where Rs is the equivalent or total resistance of the circuit.

In parallel combination, same potential difference exists across each resistor. But current through each resistance is different.

When two or more resistors are connected one after other, they are said to be connected in series as shown in figure. in this combination voltage difference across each resistance is different which is given by ohms law. current flowing through each resistance is same.

equivalent resistance for series combination is given by,

R(s) = R₁ + R₂ + R₃...........+R(n).

In this problem given resistance are not seen, Resistor can be with 41 and 17Ω.

Given,

R₁ = 17 Ω

R₂ = 41 Ω

[tex]R_{s} = ?[/tex]

by parallel combination,

[tex]\frac{1}{R_{s}} = \frac{1}{R_{1} } + \frac{1}{R_{2} }[/tex]

[tex]R_{s} = \frac{R_{1} R_{2} }{R_{1} + R_{2} }= \frac{17*41}{17+41} = \frac{697}{58} = 12[/tex]

R = 12 Ω.

Hence option D is correct.

To know more about Resistor :

https://brainly.com/question/24297401

#SPJ3.

Answer:

the anser is B

Explanation:

Answer: A. at the point which

is twice the focal lenght of the lens of the camera

Explanation:

When a certain document is to be produced through the use of a duplicating camera, it should be noted that the camera should be placed at the point which is twice the focal lenght of the lens of the camera so as to get the exact copy of the document.

It should be noted that placing the camera between the principal and a point twice the focal lens of the camera lens or beyond a point that's twice the focal length will not produce the document.

Therefore, the correct option is A

Electrons move from the wool to the rod.

BEcause if they move from wool to rod, the rod has more number of electrons now. Hence making it negatively charged

The plastic rod becomes charged when electrons move from the wool to the rod to become negatively charged. Details about charge can be found below.

Electronegativity is the tendency, or a measure of the ability, of an atom or molecule to attract electrons and thus form bonds.

According to this question, a plastic rod becomes negatively charged when it is rubbed with a piece of wool.

An atom becomes negatively charged when it gains electrons from another atom, hence, it can be said that the plastic rod becomes charged when electrons move from the wool to the rod to become negatively charged.

Learn more about charge at: https://brainly.com/question/19886264

#SPJ2

Answer:

Explanation:

By Kirchoff's laws, I1 + I2 = 3

I2 = 3 - I1

Following circuit on the left, V = summation of IRs

9 = I1*3 + 3*2

3*I1 = 9 - 6 = 3

I1 = 1A

I2 = 3 -1 = 2A

Following circuit on the right, V = summation of IRs

ε = I2*4.5 + 3*2

= 2*4.5 + 6

= 15V

Answer:

north pole of a magnet repels the north pole of another magnet no matter of their shape , size , weakness , strength ,etc .

Explanation:

Answer:

It is most likely option A B and C

Answer:

I think option A ,B,D are correct

Answer:

[tex]g=2.513m/s^2[/tex]

Explanation:

From the question we are told that:

Mass Taken [tex]m=100g \approx 100*10^{-3}[/tex]

Strain on Spring [tex]l_s=22.6cm \approx 22.6*10^{2}[/tex]

Distance pulled down [tex]d_d=10.9[/tex]

Time for ten oscillations take [tex]t=18.8s[/tex]

Generally the equation for angular velocity is mathematically given by

[tex]\omega=2\pi\\\omega=2\pi*\frac{10\ oscillations}{t}\\\\\omega=2\pif=2\pi*\frac{10\ oscillations}{18.8}\\Also\\\omega=\sqrt{\frac{k}{m}} \\\omega=\sqrt{\frac{k}{100*10^{-3}}}[/tex]

Therefore

[tex]{2\pi*\frac{10\ oscillations}{18.8}}=\sqrt{\frac{k}{100*10^{-3}}} \\k=\sqrt{2\pi*\frac{10\ oscillations}{18.8}}*100*10^{-3}\\k=1.112N/m[/tex]  

Generally the equation for Acceleration due to gravity is mathematically given by

[tex]F=mg\\mg=k l_s\\g=\frac{k l_s}{m}\\g=\frac{1.112*2.6*10^{2}}{100*10^{-3}}[/tex]

[tex]g=2.513m/s^2[/tex]

Answer:

If I'm not wrong; I think the answer is A

Explanation:

A. Increasing kinetic energy

Answer:

C I think but I'm not sure

Explanation:

Because by adding mass it would add more gravitational pull

Answer:

ok so first ur not a failure and its okay don't be so hard on ur self

Answer:I think it’s convection

Explanation:

Answer:

infinity

Explanation:

this is because time is irrelevant

Answer:

Part A

The sound intensity at the location 150 from the firework = 4.3[tex]\overline 5[/tex] W/m²

Part B

The power the firework is emitting is approximately 1,231.5 kW

Explanation:

Part A

The data of the firework sound heard by the two friends are;

Let 'A' represent the location of the friend at a point 150 m from the fireworks and let 'B' represent the location of the friend watching from a distance of 700 m from the firework

The distance of 'A' from the sound, r₁ = 150 m

The distance of 'B' from the sound, r₂ = 700 m

The intensity at which 'B' hears the sound, I₂ = 0.2 W/m²

The relationship between sound intensity and distance is given as follows;

[tex]\dfrac{I_2}{I_1} = \left (\dfrac{r_1}{r_2} \right )^2[/tex]

[tex]\therefore {I_1} = \dfrac{I_2}{ \left (\dfrac{r_1}{r_2} \right )^2} = I_2 \times \left (\dfrac{r_2}{r_1} \right )^2[/tex]

Plugging in the values gives;

[tex]\therefore {I_1} = 0.2 \times \left (\dfrac{700}{150} \right )^2 = \dfrac{196}{45} = 4.3\overline 5[/tex]

The sound intensity at location 'A', I₁ = 4.3[tex]\overline 5[/tex] W/m²

Part B

The relationship between power, 'P', and intensity, 'I', is presented as follows;

[tex]I = \dfrac{P}{4 \cdot \pi \cdot r^2}[/tex]

P = I·4·π·r² = 4·I·π·r²

Therefore, at point 'A', where the distance, r₁ = 150 m, and the intensity, I₁ = 4.3[tex]\overline 5[/tex] W/m², we have;

P = 4 × 4.3[tex]\overline 5[/tex] W/m² × π × (150 m)² = 1231504.32021 W

The power the firework is emitting, P ≈ 1,231.5 kW.

Answer:

Amplitude—distance between the resting position and the maximum displacement of the wave

Frequency—number of waves passing by a specific point per second

Period—time it takes for one wave cycle to complete

wavelength λ - the distance between adjacent identical parts of a wave, parallel to the direction of propagation.

Tension - described as the pulling force transmitted axially by the means of a string, a cable, chain, or similar one-dimensional continuous object, or by each end of a rod, truss member, or similar three-dimensional object

Answer:

1 joule per second.

Explanation:

The watt (symbol: W) is a unit of power or radiant flux. In the International System of Units (SI), it is defined as a derived unit of (in SI base units) 1 kg⋅m2⋅s−3 or, equivalently, 1 joule per second.

Answer:

C

Explanation:

C

20*9.8*0.5

98

the difference of 10 dB is considered as having 10 times the intensity, so difference of 40 dB means :

=》10 × 10 × 10 × 10

=》10000 times

so the the intensity of one sound is 10000 times the other one.

Answer:

A sound wave is called a longitudinal wave because compressions and rarefactions in the air produce it. The air particles vibrate parallel to the direction of propagation.

Answer:

64 ohms =R

Explanation:

R is directly proportional to V

R is inversely proportional to I(Current

Answer:

a = 12.2 m/s²

Explanation:

Given: 5 kg, 61N

To find: Acceleration (a)

Solution:

A = F ÷ m

= 61 ÷  5  

= 12.2 m/s²

Newtons are derived units, equal to 1 kg-m/s². In other words, a single Newton is equal to the force needed to accelerate one kilogram one meter per second squared.

Answer:

Height of tower = 480 meter

Explanation:

Given:

Initial velocity = 20 m/s

Time taken to reach ground = 8 second

So,

Final velocity = 0 m/s

Acceleration due to gravity = 10 m/s²

Find:

Height of tower

Computation:

s = ut + (1/2)(g)(t)²

s = (20)(8) + (1/2)(10)(8)²

s = 160 + (1/2)(10)(64)

s = 160 + (10)(32)

s = 160 + 320

s = 480 meter

Height of tower = 480 meter