How many protons does Silicone have

A.2
B.14
C.28
D.28.08

Answer:

3rd order polynomial

Explanation:

Given that the increase in the order of the polynomial the error between the curve fit and measured data will decreases hence  :

The polynomial order that is best to use is the 3rd order polynomial, this is because using a 3rd order polynomial will produce a less variance and a low Bias

Answer:

sublimation and evaporation

Explanation:

evaporation is from liquid to gas and sublimation is solid to liquid, as water vapor is a gas both of these methods could be used

Answer:

I think the answer is option B

Answer:

it's friction

Explanation:

100% sure about that

I probably don't have to tell you that the other answer is nonsense, but I'll do it all the same, just in case... Half-life is defined as the time it takes for some radioactive substance to decay to half its original amount.

If it takes n half-lives for some substance with a starting amount of A to decay to a final amount of B, then

[tex]B = \dfrac{A}{2^n}[/tex]

1. If the half-life is x, then after 1 half-life, 5000 units of this substance decays to 2500 units. After another half-life, this decays to 1250. After another, this in turn decays to 625.

So 3 half-lives are required.

In terms of the equation above, we solve for n such that

[tex]625 = \dfrac{5000}{2^n} \implies 2^n = 8 \implies n=3[/tex]

since 2³ = 8.

2. Count how many times you halve 15,000 to end up with 3750:

15,000/2 = 7500

7500/2 = 3750

===>   2 half-lives

In other words,

[tex]3750 = \dfrac{15,000}{2^n} \implies 2^n = 4 \implies n=2[/tex]

3. After 1 half-life, you would end up with

12,000/2 = 6000

and after another half-life,

6000/2 = 3000

i.e.

[tex]\dfrac{12,000}{2^2} = \dfrac{12,000}4 = 3000[/tex]

4. After 1 half-life, you have

26,000/2 = 13,000

After 2 half-lives,

13,000/2 = 6500

After 3 half-lives,

6500/2 = 3250

After 4 half-lives,

3250/2 = 1625

i.e.

[tex]\dfrac{26,000}{2^4} = \dfrac{26,000}{16} = 1625[/tex]

5. If the half-life is 3 years, then 15 years = 3 half-lives.

In the last 3 years, 20,000 would have decayed to 10,000.

In the second-to-last 3 years, 40,000 would have decayed to 20,000.

In the first 3 years, 80,000 would have decayed to 40,000.

i.e.

[tex]\dfrac{x}{2^3} = 10,000 \implies x = 8\times10,000 = 80,000[/tex]

Answer:

B

Explanation:

because it has more power

The Model A represents a neutral atom. hence option A is correct.

Atom is smallest entity of a body. Body is made up of atoms. it is basic building block of a body. An atom consist of electrons, protons and neutrons as sub atomic particle. whole mass of the atom is concentrated at the center of the atom which we call it as nucleus, nucleus consist of proton and neutron. Electron revolve around the nucleus at determined(fixed) orbit. Total number of protons in the atom decides the atomic number and the elements in the periodic table. The electrons which are completely filled orbitals are called as core shell electrons and which are not filled completely are called as valence electron. valence electrons are responsible for physical and chemical properties of the element. Elements which are on same column in periodic table have same number of valence electrons . Hence they have same properties.

Atomic number of Nitrogen is 7. Hence neutral atom of nitrogen has 7 electrons in his orbits.

Hence option A is correct.

To know more about Atom :

https://brainly.com/question/30898688

#SPJ5.

I think the answer for the following question is A.

Answer:

There is only a beat frequency when the frequency heard (perhaps a tuning fork) is different from the frequency from  the object in question (piano string, etc.).

The beat frequency equals the difference of the frequencies of the sources.

The piano tuner should adjust the tension in the wire to: C. decrease the amount of interference and decrease the beat frequency.

A wave can be defined as a disturbance created in a medium, which progressively transports energy from a source to another location without the transportation of matter.

Basically, some of the phenomenon and properties associated with waves include the following:

An interference refers to a phenomenon in which two (2) waves meet while traveling along the same medium and they superpose to produce a resultant wave with either a lower, greater, or the same amplitude.

In this scenario, a beat frequency is being heard by a piano tuner when using a tuning fork to tune a piano wire. Thus, the piano tuner should adjust the tension in the wire, so as to decrease the amount of interference and the beat frequency.

Read more: https://brainly.com/question/14929897

Answer:

C

Explanation:

During investigations a scientist needs to observe, investigate, collect data and put together the information they collect.

Answer:

degree

liquid

mass-volume

Explanation:

Answer:

Work done against gravity in lifting an object becomes potential energy of the object-Earth system. The change in gravitational potential energy, ΔPEg, is ΔPEg = mgh, with h being the increase in height and g the acceleration due to gravity.

Explanation:

Answer:

The answer is B. :)

Explanation:

The hot air balloon reaches the highest height turn on the flame for 10 seconds each minute for 2 minutes and cut a large hole in the balloon material to allow excess air out.

Because hot air rises, hot air balloons work. By using the burner to heat the air inside the balloon, it becomes lighter than the cooler air on the outside.

As a result, the balloon floats upwards, as if it were in the water. Obviously, allowing the air to cool causes the balloon to slowly deflate.

Hot air balloons use a flame that can turn on and off to heat air inside a large balloon. The balloon is attached to a basket that can carry people or cargo as it is lifted off the ground and floats in the air.

Turn on the flame for 10 seconds each minute for 2 minutes, and cut a large hole in the balloon material to allow excess air out.

Hence the hot air balloon reaches the highest height turn on the flame for 10 seconds each minute for 2 minutes and cut a large hole in the balloon material to allow excess air out.

To learn more about the hot air balloon refer to the link;

https://brainly.com/question/11178349

Answer:

I am not sure really.

Explanation:

I just don't know

Answer:

9.59 turns

Explanation:

A test tube looks like cylinder, we can say it has a cross section of circle- like. Then the circumference of the test tube can be determined,Then use it to divide length of the string which answered the question.

Circumference of the tube=( π d)

Where d= diameter

π= 3.142

If we substitute the values, we have

= (3× 3.142)= 9.42cm

length of the string= 90.42cm

Circumference of the tube= 9.42cm

Number of turns around the test tube=

=( length of the string) /Circumference of the tube

=(90.42 ÷ 9.42)

= 9.59cm

Answer:

at location 4

Explanation:

it is because the solar eclipse happens when the moon is covering the sun

What help do you want? If you tell, I may help you.

Answer:

2100 N

Explanation:

[tex]v = u + at \\ 0 = 35 + a(5) \\ a = - 7m {s}^{ - 2} \\ \\ net \: force \: = ma \\ = (300)(7) \\ = 2100 \: newtons[/tex]

Large object moving, small object at rest:

v = 18.18m/s

Small object moving, large object rest:

v= 6.81m/s

Explanation:

p = mv

m1•Vi1 + m2•Vi2 = m1•Vf1 + m2•Vf2

First Scenario (large object moving):

For small object,

p=mv

p= 3kg • 0 = 0

For large object,

p= mv

p= 8kg • 25m/s = 200kg•m/s

Combined,

p1+p2 (small object + large object) = 200m/s

After the collision, there is one mass,

new mass is 8kg + 3kg = 11kg

So now , p = mv again. In this case

200m/s = (11kg)•v

v = (200kg•m/s)/(11kg) = 18.18 m/s

Second Scenario (small object moving):

p1v1 = 3kg•25m/s = 75kg•m/s

p2v2 = 8kg•0 = 0

p1v1 + p2v2 = 75kg•m/s

New mass = 8kg+ 3kg = 11kg

p = mv

75kg•m/s = 11kg•v

v = (75kg•m/s)/11kg = 6.81m/s

Answer:

140km/h

Explanation:

Average speed= Distance/Time

= 210/1.5

= 140 I'm/h

Answer: d

Explanation:

Answer:

Sorry I didn't know the answer

Answer:

Explanation:

En física, las líneas de campo son una ayuda para visualizar un campo electrostático, magnético o cualquier otro campo vectorial estático

The answer shud be 31 . 14m

Answer:

Explanation:

The force of 80N is applied on sled at 53⁰

Its horizontal  component = 80cos53

= 48.14 N .

Its horizontal component will pull forward the sled and friction will prevent its forward motion . As sled is moving with constant velocity , net force on it is zero .

Hence forward push = frictional force

Frictional force = 48.14 N.

Answer:

F(m)= mg(m)

m=F(m)/g(m)=72/1.6=45kg

F(e)= mg(e)= 45 x 10 m/s= 450N