guys please finnish thiissss​

Answer: this is the explanation

Explanation:

the temperature of a substance is related to the average kinetic energy of the particles of that substance. When a substance is heated, some of the absorbed energy is stored within the particles, while some of the energy increases the motion of the particles

Answer:

c

Explanation:

Answer:

d would be both liquids and gasses

Explanation:

Answer:

A. Gases

B. Solids

C. Gases

D. liquids and solids

So basically all ur answers are right except D

Explanation:

Brainlist?

Answer:

2.

Explanation:

Beacuse they are all group 1 metals. All have the same boiling, melting point and reactivity due to one electron in its outer shell.

Potassium(k), rubidium(Rb), and cesium(Cs) are the three elements from the given list that have the most similar chemical properties.

Therefore the correct answer is option 2.

The total number of protons present in an atom is known as the atomic number of that atom. The atomic number has no correlation either with the number of neutrons or the number of electrons present inside an atom.

While the atomic mass of an atom is the sum of the total number of protons and the number of neutrons present inside of any atom.

From the list of elements, potassium (k), rubidium (Rb), and cesium (Cs) are the three that share the most chemical similarities.

Thus, option 2 is the right response.

To learn more about the atomic number from here, refer to the link;

brainly.com/question/14190064

#SPJ6

Answer:

Due to the decrease in the gravitational force, it will take longer time for ball to reach the ground while dribbling. Moreover, the hang time of players will also be longer. This means that the players will stay on air longer and will be able to jump higher.

Answer: this is how it works

Explanation:

The magma bursts through Earth's surface in the form of a volcano. Heat and pressure deep in the Earth makes some rocks change to metamorphic rock. Layers of rock get squashed and packed together and gradually harden to form sedimentary rock. The igneous rock gets broken down by weather, and the cycle begins again.

Answer:

[tex]l = 0.793[/tex] cm

Explanation:

Let us assume the density of block square [tex]10[/tex] g/cm³

As we know

Volume = [tex]\frac{Mass}{Density}[/tex]

Thus Volume of this block is equal to [tex]\frac{5}{10} = 0.5[/tex]

As we know volume of square block of side of length "l" is equal to [tex]l^3[/tex]

[tex]l^3 = 0.5[/tex]

[tex]l = 0.793[/tex] cm

Answer:

the volume will increase

Explanation:

The kinetic energy of gas molecules depend upon the temperature . If temperature is increased , the molecules will move faster . When temperature is decreased , they move slower .

Hence when more molecules are added to a gas without changing its temperature , the velocity of gas molecules will remain unchanged .

Since pressure  is also constant , it is volume which will be increased .

It can be explained from universal gas formula as follows

PV = nRT

P , R and T is constant ,

V ∝ n

Volume is proportional to n which depends upon number of molecules .

So volume will increase if number of molecules increases .

Answer:

Seismic waves are produced when suddenly released some sort of energy stored in Earth's crust, usually when suddenly fracture and "slip" masses of rock straining against each other. Earthquakes occur most frequently along geological faults, narrow zones where rock masses shift in relation to each other.

Explanation:

Hope This Helped. :)

Answer:

236 g/mol

Explanation:

This question is asking to calculate the molar mass/formula mass of calcium nitrate tetrahydrate with the chemical formula: Ca(NO3)2 · 4H20. This is done as follows:

Atomic mass of the constituent elements are as follows:

Ca = 40

N = 14

O = 16

H = 1

Hence, in Ca(NO3)2 · 4H20.

= 40 + {14 + 16(3)}2 + 4 {1(2) + 16}

= 40 + {14 + 48}2 + 4{2 + 16}

= 40 + {62}2 + 4{18}

= 40 + 124 + 72

= 236

Hence, the molar mass of Ca(NO3)2 · 4H20 is 236g/mol.

Answer:

236 g/mol

Explanation:

Answer:

Cation and anion

Explanation:

Positive ion is known as cation and negative ion is known as anion

Answer:

V = 18,493.5114 cm³

Explanation:

Dimensions are;

L = 35 inches

W = 35 cm

H = 0.065 yards

Now, volume is given by;

V = LWH

But our dimensions need to all be in the same unit, so let's convert to cm.

L = 35 inches = 35 × 2.54 cm = 88.9 cm

H = 0.065 yards = 0.065 × 91.44 = 5.9436 cm

Thus;

V = 88.9 × 35 × 5.9436

V = 18,493.5114 cm³

Answer:

N2O5

Explanation:

Empirical formular is the simplest formular of a compound and shows the atoms present in simple rations.

Molecular formular on the other hand shows the exact number of atoms of element present in a compound.

To obtain molecular formular from empirical formular;

(Empirical formular)n = Molar mass

where n is a simple integer.

(N2O5)n = 108 g/mol

Molar mass of N2O5 = 108 g/mol

(108) n = 108

n = 108 / 108 = 1

Molecular formular = (Empirical formular)n

Molecular formular = (N2O5)*1 = N2O5

In this question, the empirical formular is the same as the molecular formular

Answer:

2CH4 ------> 3H2 + C2H2

Explanation:

The law of conservation of mass states that atoms can neither be created nor destroyed in a chemical reaction.

The implication of this law is that the number of atoms of each element on the reactant side must be equal to the number of atoms of each element on the product side.

This law is only obeyed by the reaction, 2CH4 ------> 3H2 + C2H2

There were eight atoms of H on the left hand side as well as the right and side of the reaction equation. There were two atoms of C on both the left and right hand sides of the reaction equation respectively. Hence, the law was obeyed here.

disolvin rate is The rate at which a solute dissovles depends upon the size of the solute particles. Dissolving is a surface phenomenon since it depends on solvent molecules colliding with the outer surface of the solute.

saturation the degree or extent to which something is dissolved or absorbed compared with the maximum possible, usually expressed as a percentage.

changes in solubility  For many solids dissolved in liquid water, the solubility increases with temperature. The increase in kinetic energy that comes with higher temperatures allows the solvent molecules to more effectively break apart the solute molecules that are held together by intermolecular attractions.

The concentration of a solution is a measure of the amount of solute that has been dissolved in a given amount of solvent or solution. A concentrated solution is one that has a relatively large amount of dissolved solute. A dilute solution is one that has a relatively small amount of dissolved solute.

dilution is the making something weaker in force, content, or value.

Colligative properties of solutions are properties that depend upon the concentration of solute molecules or ions, but not upon the identity of the solute. Colligative properties include vapor pressure lowering, boiling point elevation, freezing point depression, and osmotic pressure.

Answer:

The law of conservation of mass states that mass in an isolated system is neither created nor destroyed by chemical reactions or physical transformations. According to the law of conservation of mass, the mass of the products in a chemical reaction must equal the mass of the reactants.

Answer:

it could depend on the environment of the area, how the sun rays are parting through particles in the air, or it jus might be the amount of heat radiation is coming down cause it could be a chilly sunny day or a hot sunny day

Answer:

because is made of more than on type of atom

HCl as a limiting reactant

volume of the gas(H₂)= 0.672 L

mass of salt : =2.67 g

mass of excess left :  4.86 g

Given

5.4 g Al

300 mL of 0.2 mol/L HCl

Required

limitng reactants

volume of the gas(H₂)

mass of salt

mass of excess left

Solution

Reaction

2Al + 6HCl → 2AlCl₃ + 3H₂

mol Al = 5.4 g : 27 g/mol = 0.2

mol HCl = 0.3 L x 0.2 mol/L = 0.06

mol : coefficient of reactants :

Al = 0.2 : 2 = 0.1

HCl = 0.06 : 6 = 0.01

HCl as a limiting reactant(smaller ratio)

Al as an excess reactant

mol H₂ = 3/6 x mol HCl = 3/6 x 0.06 = 0.03

volume (STP : 1 mol=22.4 L) :

= 0.03 x 22.4 L

= 0.672 L

mol AlCl₃ = 2/6 x mol HCl = 2/6 x 0.06 = 0.02

mass AlCl₃ :

= mol x MW

= 0.02 x 133.5

=2.67 g

mol (reacted) : 2/6 x mol HCl = 2/6 x 0.06 = 0.02

mol (unreacted) : 0.2 - 0.02 = 0.18

mass = 0.18 x 27 g/mol = 4.86 g

Answer:

S<Se<Te

Br<Ni<K

F<Si<Ba

Explanation:

Answer:

139 mL

Explanation:

Given data:

Volume of solution required = ?

Molarity of solution = 0.222 M

Mass of salt = 9.57 g

Solution:

Number of moles of manganese iodide:

Number of moles = mass/molar mass

Number of moles = 9.57 g/ 308.75 g/mol

Number of moles = 0.031 mol

Volume required:

Molarity = number of moles of solute / volume in L

0.222 M = 0.031 mol / V

V = 0.031 mol / 0.222 mol/L

V = 0.139 L

Volume in mL:

0.139 L ×1000 mL / 1 L

139 mL

Answer:

An initial velocity that is faster than a final velocity

Explanation:

The relationship between velocity and acceleration is given as follow;

Acceleration = Change in velocity / Time

Change in Velocity = Final Velocity - Initial Velocity

From the formular, time is not able to affect the sign of the acceleration.

A negative acceleration is also referred to as deceleration and this occurs when there is a drop in velocity.

A drop in velocity occurs when the initial velocity is faster than the final velocity.

1. Double-Replacement reactions

2. Decomposition  

3. Combustion

4. Syntesis

5. Single replacement

Given

Chemical equations

Required

Type of reaction

Solution

1. 2AgNO₃ + MgCl₂ ⇒ 2AgCl + Mg(NO₃)₂

Double-Replacement reactions. Happens if there is an ion exchange between two ion compounds in the reactant

2. 2KBr⇒2K +Br₂

Decomposition  

Single compound breaks down in to 2 or more products

3. C₃H₈ + 5O₂ ⇒ 4H₂O + 3CO₂

Combustion

Hydrocarbon and Oxygen reaction and form water and carbon dioxide

4. NaO + H₂O ⇒ NaOH

Syntesis

2 or more reactants combine to form a single product

5. Zn + CuCl₂ ⇒ZnCl₂ + Cu

Single replacement

One element replaces another element from a compound

Answer:

sediments

Explanation:

Explanation:

The equation of the reaction is;

H2O2 + N2H4 → N2 + H2O

Upon balancing the reaction, we have;

N2H4 + 2H2O2 → N2 + 4H2O  

a. How many moles of N2 are formed from 0.0250 moles of N2H4?

From the equation of the reaction;

1 mol of N2H4 produces 1 mol of N2

0.0250 mol of N2H4 would produce x mol of N2

1 = 1

0.0250 = x

x = 0.0250 * 1 / 1 = 0.0250 mol

b. How many moles of H2O2 are required if 1.35 moles of H2O is to be produced?

From the equation of the reaction;

2 mol of H2O2 produces 4 mol of H2O

x mol of H2O2 produces 1.35 mol of H2O

2 = 4

x = 1.35

x = 1.35 * 2 / 4 = 0.675 mol

c. How many moles of H2O are formed if 1.87 moles of N2 is produced?

The relationship between H2O produced and N2 is;

For every 1 mol of N2 produced, 4 mol of H2O is produced

1.87 mol of N2 produced, how many moles of H2O is produced?

1 = 4

1.87 = x

x = 1.87 * 4 / 1 = 7.48 mol

Answer:

A, 4,3,3,4

B, 3,2,2,3

C, 2,6,2,3

D, 1,2,1, 1