PLEASE HELP !!!!!!!!!!

If everything else remains constant, then the received signal power is simply an inverse-square function of its distance from the transmitter.

That is, down 6dB when distance is doubled etc.

If distance increases from 16 to 20, then received power decreases by the factor of (16/20)^2.

That's (0.8)^2 = 0.64

New receive power is 5x0.64 = 3.2 nW

=. ===== ==========

Here's how I do it at my job:

Initial RSL = 5nW ~ - 53 dBm

loss = 20log(20/16)= 20log(1.25)~1.94dB

New RSL = - 54.94 dBm or ~ 3.2 nW .

Answer:

Weight = 8.162 Newton.

Explanation:

Given the following data;

Mass = 2.2 kg

Acceleration due to gravity = 3.71 N/kg

To find the weight of the textbook;

Weight = mass * acceleration due to gravity

Weight = 2.2 * 3.71

Weight = 8.162 N

Therefore, the weight of the science textbook in mars is 8.162 Newton.

The frequency of the waves will be 18 Hz. Then the correct option is B.

The frequency of a repeated event is its number of instances per unit of time. It differs from angular frequency and is sometimes referred to as temporal frequency for clarification. One event occurs per second when measuring frequency in hertz.

Frequency is the number that represents the number of oscillations or intervals each second. The hertz is the SI unit for frequency (Hz). One cycle per second equals one hertz.

The number of finished waves produced each second is considered the wave frequency.

Six wave crests pass a fisherman sitting at the end of a pier in the span of three seconds.

The frequency of the waves is given as,

f = 6 x 3

f = 18 Hz

The waves will have a frequency of 18 Hz. Then, choice B is the best one.

More about the frequency link is given below.

https://brainly.com/question/29739263

#SPJ6

Answer: 0.1125A

Explanation:

We need to know the total resistance which will be:

R = R1+R2

where,

R1 = 20 ohm

R2 = 60 ohm

Therefore, R = 20 + 60 = 80 ohm

We should note that from Ohm's law

v = iR

i = v/R

where,

i = 9/80 = 0.1125 A

Therefore, the current that flows out of the battery is 0.1125A

Answer:

the maximum current is 500 A

Explanation:

Given the data in the question;

the B field magnitude on the surface of the wire is;

B = μ₀i / 2πr

we are to determine the maximum current so we rearrange to find i

B2πr = μ₀i

i = B2πr / μ₀

given that;

diameter d = 2 mm = 0.002 m

radius = 0.002 / 2 = 0.001 m

B = 0.100 T

we know that permeability; μ₀ = 4π × 10⁻⁷ Tm/A

so we substitute

i = (0.100)(2π×0.001 ) / 4π × 10⁻⁷

i = 500 A

Therefore, the maximum current is 500 A

Answer:

the answer is 86400seconds.

Explanation:

1day= 24 hours

24hours to seconds =

24×60×60= 86400 seconds.

( 60 second = 1 minutes)

( 60 minutes = 1 hour)

Answer:

0.2 seconds

Explanation:

f=1/t

1/5=0.2

Answer:

(1.9756, -2.1951)

Explanation:

The center of mass equation is: [tex]x_{cm}[/tex] = [tex]\frac{m_{1}x_{1} + m_{2}x_{2} + m_{3}x_{3} + m_{4}x_{4} + m_{5}x_{5} + m_{6}x_{6}}{m_{1} + m_{2} + m_{3} + m_{4} + m_{5} + m_{6}}[/tex], where m represents the masses and x represents the position.

In order to find the coordinates of the center of mass, we need to use this equation for both the x-values and the y-values.

x-values:

[tex]x_{cm}[/tex] = [tex]\frac{m_{1}x_{1} + m_{2}x_{2} + m_{3}x_{3} + m_{4}x_{4} + m_{5}x_{5} + m_{6}x_{6}}{m_{1} + m_{2} + m_{3} + m_{4} + m_{5} + m_{6}}[/tex] = [tex]\frac{4(-1)+6(4)+7(-3)+10(5)+2(-2)+12(3)}{4+6+7+10+2+12}[/tex] = [tex]\frac{(-4)+(24)+(-21)+(50)+(-4)+(36)}{41}[/tex] = [tex]\frac{81}{41}[/tex] = 1.9756

y-values:

[tex]y_{cm}[/tex] = [tex]\frac{m_{1}y_{1} + m_{2}y_{2} + m_{3}y_{3} + m_{4}y_{4} + m_{5}y_{5} + m_{6}y_{6}}{m_{1} + m_{2} + m_{3} + m_{4} + m_{5} + m_{6}}[/tex] = [tex]\frac{4(1)+6(2)+7(-2)+10(-4)+2(4)+12(-5)}{4+6+7+10+2+12}[/tex] = [tex]\frac{(4)+(12)+(-14)+(-40)+(8)+(-60)}{41}[/tex] = [tex]\frac{-90}{41}[/tex] = -2.1951

center of mass:

(1.9756, -2.1951)

Answer:

A

Explanation:

if it was B it would say from one to another to another

Answer:

Answer:

A·B = 4

Explanation:

Given that,

Vector A = 2i+3j-3k

Vector B = -i+5j+3k

We need to find the value of A·B.

We know that,

i·i=j·j=k·k = 1 and i·j=j·k=k·i=0

So,

[tex]A\cdot B=(2i+3j-3k)\cdot (-i+5j+3k)\\\\=-2+5(3)+(-3)(3)\\\\=-3+15-9\\\\=4[/tex]

So, the value of A·B is equal to 4.

Answer:

it's A subduction, deep water trench

Answer: 5.08 L.

Explation down below

Answer:

hey iam bored pls join

ID: 724 645 3790

Password: 1111

The term change refers to an alteration of present conditions.

The term change refers to an alteration of present conditions. When a change occurs, things cease to be the way they were. As a student, the complexity of academic work increases with time. This is a change that has taken place.

As an employee, you are given real world tasks to accomplish rather than mere mental exercises like when you were a student, this is change that has taken place.

Learn more about change: https://brainly.com/question/11739819

Answer:

636.6 W/m²

Explanation:

From the given information:

The area of the circular spot can be calculated as:

A = πr²

A = π(0.5 × 10⁻³ m)²

A = 7.85 × 10⁻⁷ m²

The intensity can be determined by using the formula:

[tex]I = \dfrac{P}{A}[/tex]

[tex]I = \Big ( \dfrac{0.500 \ mW}{\pi (0.5 \times 10^{-3} \ m )^2} \Big) \Big( \dfrac{10^{-3} \ W}{1\ mW} \Big)[/tex]

[tex]I = \dfrac{0.500 \times 10^{-3} }{\pi(0.25 \times 10^{-6} )}[/tex]

I = 636.6 W/m²

Answer:

22Volts

Explanation:

The pd at the terminal is known as the emf

Since there are Ten 2.2V cells

Terminal voltage = number of cells * pd of one cell

Terminal voltage = 10 * 2.2

Terminal voltage = 22V

Hence the pd at the battery terminals​ is 22Volts

Answer:

none no work cuz no motion

Explanation:

GOOD LUCK

Answer: 0.83 m

Explanation:

Given

mass of the block is m=3 kg

spring constant k=98 N/m

The Speed at the time of collision is v=1.5 m/s

Here, the kinetic energy of the block is converted into Elastic potential energy

[tex]\Rightarrow \dfrac{1}{2}mv^2=\dfrac{1}{2}kx^2 \\\\\Rightarrow 3\times 1.5^2=98\times x^2\\\\\Rightarrow x^2=0.6887\\\\\Rightarrow x=0.829\approx 0.83\ m[/tex]

Answer:

The required angular speed the neutron star is 10992.32 rad/s

Explanation:

Given the data in the question;

mass of the sun M[tex]_S[/tex] = 1.99 × 10³⁰ kg

Mass of the neutron star

M[tex]_N[/tex] = 2( M[tex]_S[/tex] )

M[tex]_N[/tex] = 2( 1.99 × 10³⁰ kg )

M[tex]_N[/tex] = ( 3.98 × 10³⁰ kg )

Radius of neutron star R[tex]_N[/tex] = 13.0 km = 13 × 10³ m

Now, let mass of a small object on the neutron star be m

angular speed be ω[tex]_N[/tex].

During rotational motion, the gravitational force on the object supplies the necessary centripetal force.

GmM[tex]_N[/tex] = / R[tex]_N[/tex]² = mR[tex]_N[/tex]ω[tex]_N[/tex]²

ω[tex]_N[/tex]² = GM[tex]_N[/tex] = / R[tex]_N[/tex]³

ω[tex]_N[/tex] = √(GM[tex]_N[/tex] = / R[tex]_N[/tex]³)

we know that gravitational G = 6.67 × 10⁻¹¹ Nm²/kg²

we substitute

ω[tex]_N[/tex] = √( (  6.67 × 10⁻¹¹ )( 3.98 × 10³⁰ ) ) / (13 × 10³ )³)

ω[tex]_N[/tex] = √( 2.65466 × 10²⁰ / 2.197 × 10¹²

ω[tex]_N[/tex] = √ 120831133.3636777

ω[tex]_N[/tex] = 10992.32 rad/s

Therefore, The required angular speed the neutron star is 10992.32 rad/s

Answer:

c. turn downward

Explanation:

From the information given:

To find the tendency of the sander;

We need to apply the right-hand rule torque; whereby we consider the direction of the flywheel, the direction at which the torque is acting, and the movement of the sander toward the right.

Since the flywheel of the sander is in counterclockwise movement, hence the torque direction will be outward placing on the wall. However, provided that the movement of the sander is toward the right, then there exists an opposite force that turns downward which showcases the tendency in the sander is downward.

Answer:

electromagnetic waves only

Explanation:

I just took the test, Hope it helps!

Answer:

A: Electromagnetic waves only

Explanation:

Answer:

(a) m³

Explanation:

Joule is the unit of work and Pascal is unit of pressure.

J/Pa = work/pressure = Nm/Nm⁻² = m³

Thus, The unit J/Pa is equivalent to m³

-TheUnknownScientist

Answer:

Altitude is the height of landmass calculated from sea level. No it has no effect on weight.

Explanation:

The altitude at sea level is always assumed to be 0°, thus as you move away from altidude is calculated in increments while moving into the sea, the vice versa is true.

Answer:

1st and 2nd

Explanation:

Explanation:

3

i believe that they are all going at 3.2 meters each, I did 4 times 0.8

The velocity of each electron at the corners of the square is 15.92 m/s.

The given parameters;

The diagonal length of the square is calculated as;

[tex]d^2 = 0.8^2 + 0.8^2\\\\d = \sqrt{0.8^2 + 0.8^2} \\\\d = 1.13 \ m[/tex]

The distance of each corner charge and the middle charge is calculated as;

[tex]r = \frac{1.13}{2} \\\\r = 0.565 \ m[/tex]

The force between each corner charge and the middle charge is calculated as;

[tex]F= \frac{kq^2}{r^2}[/tex]

The centripetal force on each charge moving around the square is calculated as;

[tex]F = \frac{mv^2}{r}[/tex]

solve the forces together;

[tex]\frac{mv^2}{r} = \frac{kq^2}{r} \\\\v^2 = \frac{kq^2}{m} \\\\v = \sqrt{ \frac{kq^2}{m} } \\\\v = \sqrt{ \frac{(9\times 10^9) \times (1.602\times 10^{-19})^2}{9.11 \times 10^{-31}} } \\\\v = 15.92 \ m/s[/tex]

Thus, the velocity of each electron at the corners of the square is 15.92 m/s.

Learn more here:https://brainly.com/question/13219544

Answer:

If we are upset, often our mind cannot think straight. we need to take deep breaths, and focus on reality. When we are upset we do things out of anger.

Explanation:

Hope this helps!