A certain capacitor has rectangular plates 56cm by 20cm and the gap width is .21mm. what is it's capacitance? A certain capacitor has rectangular plates 56 cm by 20 cm, and the gap width is 0.21 mm. What is its capacitance? We see that typical capacitances are very small when measured in farads. A one-farad capacitor is quite extraordinary! Apparently it has a very large area A (all wrapped up in a small package), and a very small gap s.

Answer:

C.1 is a waxing gibbous and 5 is a waning crescent.

Answer:

Magma from the core

Explanation:

...?

Answer:

Once you've had chickenpox you can't again.

Explanation: the virus remains inactive in your nerve tissue. Although it's unlikely you will get chickenpox again, the virus may reactivate later in life and cause a related condition called shingles.

Answer:

C.Supersaturated

Explanation:

There are three types of solution:

SATURATED SOLUTION:

It is the solution that contains maximum amount of solute dissolved in a solution in normal conditions.  

UNSATURATED SOLUTION:

It is the solution that contains less than the maximum amount of solute dissolved in a solution in normal conditions. It has space for more solute to be dissolved in it.

SUPERSATURATED SOLUTION:

It contains more than the maximum amount of solute dissolved in it. Such a solution has no capacity to dissolve any more solute under any conditions.

Since the sugar is no more dissolving in the tea and has settled down. Therefore, the solution is:

C.Supersaturated

the answer is 165J

1/2×3.9×(9.2)^2 = 165J

Answer:

please give me brainlist and follow

Explanation:

topographic map

A topographic map shows a three-dimensional representation of a flat surface. It has contour lines joining points of equal elevation; the closer the lines are the steeper the elevation is.

Answer:

true

Explanation:

if all forces are equal then there would be no stronger force to give any net force so it would be zero

Answer:

its the last question

Explanation:

Thats because erosion takes away stuff

Answer:

1000 m

Explanation:

Given that,

The frequency of radio waves f = 300,000 Hz

We need to find the wavelength of these waves.

The formula to find wavelength is as follows :

[tex]c=f\lambda\\\\\lambda=\dfrac{c}{f}\\\\\lambda=\dfrac{3\times 10^8}{300000}\\\\\lambda=1000\ m[/tex]

So, the wavelength of these waves is 1000 m.

Answer:

The average speed for the runner B for the first 25 seconds was;

30/25 = 1.2 m/s

Explanation:

The average speed of an object is given by the following formula

[tex]Average \ speed = \dfrac{Total \ distance \ covered}{Total \ time \ taken \ to \ cover \ the \ distance}[/tex]

From the graph, we have;

The coordinates of the runner B at the start = (0, 0)

The coordinates of the runner B after 25 seconds = (25, 30)

The total distance covered by the runner B after 25 seconds = The difference between the position at 25 seconds and the origin which is 30 meters

∴ The total distance covered by the runner B after 25 seconds = 30 meters

The time it takes the runner B to cover the distance = The 25 seconds

[tex]\therefore \ For \ the \ runner \ B, the \ average \ speed = \dfrac{30 \ meters}{25 \ seconds} = 1.2 \ m/s[/tex]

The average speed for the runner B for the first 25 seconds = 30 m/(25 s) = 1.2 m/s.

Answer:

B. [tex]\frac{218}{85} At[/tex]

Explanation:

A P E X

The nucleus that completes the following equation is ²²⁶Ac₈₉

²²²Fr₈₇ →⁴He₂ +  ²²⁶Ac₈₉

Therefore the correct answer is option C.

The phenomenon of Radioactive decay is a type of nuclear reaction in which the unstable nucleus of a radioactive element lose energy in the form of nuclear radiation, some examples of radioactive decay are alpha decay, decay, and beta decay.

The complete equation for the nuclear reaction is

²²²Fr₈₇ →⁴He₂ +  ²²⁶Ac₈₉

For the given problem the nucleus completes the given equation is  ²²⁶Ac₈₉. The correct answer is option C.

learn more about radioactive decay

brainly.com/question/1770619

#SPJ2

Answer:

B. Objects do not have to touch each other to experience a force.

Explanation:

For example ..One of the noncontact forces is magnetic force whereby a magnetic object will be attracted to another magnetic object of oppsite charged particles, through waves called electromagnetic waves. On the other hand, the two magnetic objects of similar charged particles can repel through electromagnetic waves..

Answer:

1, Coal,oil,natural gas,petroleum ...etc

2, -they pollute the environment

-In case of irresponsible use ,they can be

dangerous

-it is more reliable an renewable

Answer:

fire

Explanation:

burning the the oil

Explanation:

Wave speed  =  (frequency)  x  (wavelength)

                      =  (266 /sec)  x  (1.3 meters)

Answer:

hi

Explanation:

as a result of the collision of hot and cold air

hope it helps

have a nice day

Answer:

Hey mate.....

Explanation:

This is ur answer.....

Wind is the movement of air caused by the uneven heating of the Earth by the sun. ... Warm equatorial air rises higher into the atmosphere and migrates toward the poles. This is a low-pressure system. At the same time, cooler, denser air moves over Earth's surface toward the Equator to replace the heated air.

Hope it helps!

Brainliest pls!

Follow me! :)

Answer:

A. 12,240.

Explanation:

1,530 times 8.0 = 12,240.

hope this helped :)

Answer:

6.67×10¯⁹ A

Explanation:

From the question given above, the following data were obtained:

Quantity of electricity (Q) = 2 μC

Time (t) = 5 mins

Current (I) =?

Next, we shall convert 2 μC to C. This can be obtained as follow:

1 μC = 1×10¯⁶ C

Therefore,

2 μC = 2 μC × 1×10¯⁶ C / 1 μC

2 μC = 2×10¯⁶ C

Next, we shall convert 5 mins to seconds. This can be obtained as follow:

1 min = 60 secs

Therefore,

5 min = 5 min × 60 sec / 1 min

5 mins = 300 s

Finally, we shall determine the current in the circuit. This can be obtained as follow:

Quantity of electricity (Q) = 2×10¯⁶ C

Time (t) = 300 s

Current (I) =?

Q = It

2×10¯⁶ = I × 300

Divide both side by 300

I = 2×10¯⁶ / 300

I = 6.67×10¯⁹ A

Thus, the current in the circuit is 6.67×10¯⁹ A

Explanation:

1. Low-energy particle detector: This particle detector measures the charged particles of the solar winds.

2. Magnetometer boom: This device measures magnetic fields produced by astronomical bodies.

3. High-gain antenna: A HGA has a narrow radio beam that is used to enhance the strength of signal. They simply amplify the weak signals.

4. Photopolarimeter: This is an instrument that is used to measure the strength and intensity and polarization of reflected light.

Answer:

what they said

Explanation:

Answer:

Displacement (km)

Explanation:

The y axis is the vertical axis pointing up and down. This is labeled as the the displacement (km) in the graph.

Answer:

Flask 1

Explanation:

when volume goes down pressure goes up, and the first flask has the smallest volume therefore the greatest pressure

We have that from the ideal gas equation that the flask with the lowest volume will have the highest pressure therefore

Flask one has the lowest Pressure

Option D

From the question we are told

Each of these flasks contains the same number of gas molecules. In

which container is the pressure highest

Generally the equation for an Ideal gas given as   is mathematically given as

The ideal gass equation

[tex]PV=nRT[/tex]

Where

P=pressure

V=Volume

n=No of mole

R=Gas Constant

T=temperature

Therefore We have that from the ideal gas equation that the flask with the lowest volume will have the highest pressure therefore

Flask one has the lowest Pressure

For more information on this visit

https://brainly.com/question/13338592?referrer=searchResults

Answer:

the coefficient of friction

Answer:

The difference between the sidereal and synodic months occurs becuase as our moon moves around the earth, the earth also moves around our sun. Our moon must travel a little farther in its path to make up for the added distance and complete the phase cycle.

Explanation:

Hope this helps.

Answer:

1.876 J

Explanation:

First, let’s calculate the compression of the spring from the Hooke’s law:

F=kx,

here, F=75 N is the force acted on the spring, k=1500 N⁄m is the force constant of the spring, x is the compression of the spring.

Then, we get:

x=F/k=(75 N)/(1500 N/m)=0.05 m.

Finally, we can find the potential energy stored in the spring:

PE=1/2 kx^2=1/2∙1500 N/m∙(0.05 m)^2=1.875 J.

correct my answer if it's wrong ^^