Electronic configuration of 11N
Answer:
The Electronic configuration of 11N is
[Ne]3s1
2. A 90 g bag of trail mix is contains 22% nuts, 35% granola, 18% dried fruit. The rest is chocolate chips.
Calculate how many grams of each component there is.
nute
a pencil is 7 in Long what is its length in centimeters
look the following picture i think that will help you too find out answer
A black compound reacts with acid to give a blue green solution. Name the compound. Write the reaction
Answer:
compound is CuO.
Explanation:
rxn:
CuO + 2HCl = CuCl2 (Blue green color) + H2O
5(3x) - 7y2=?, when x = 3 and y= 2
Answer:
This might help u......
Bombardier beetles inject boiling hydrogen peroxide, or H2O2, into the victims. It then decomposes into hydrogen and oxygen gas. How many grams of oxygen can be produced if 0.128 grams of hydrogen peroxide are decomposed?
Answer:
0.12 g of O2.
Explanation:
We'll begin by writing the balanced equation for the reaction. This is given below:
H2O2 —> H2 + O2
Next, we shall determine the mass of H2O2 that decomposed and the mass of O2 produced from the balanced equation. This is illustrated below:
Molar mass of H2O2 = (2×1) + (16×2)
= 2 + 32
= 34 g/mol
Mass of H2O2 from the balanced equation = 1 × 34 = 34 g.
Molar mass of O2 = 16×2 = 32 g/mol
Mass of O2 from the balanced equation = 1 × 32 = 32 g
Summary:
From the balanced equation above,
34 g of H2O2 decomposed to produce 32 g of O2.
Finally, we shall determine the mass of O2 produced from the decomposition of 0.128 g of H2O2. This can be obtained as follow:
From the balanced equation above,
34 g of H2O2 decomposed to produce 32 g of O2.
Therefore, 0.128 g of H2O2 will decompose to produce = (0.128×32)/34 = 0.12 g of O2.
Therefore, 0.12 g of O2 was produced.
Explain The process of a pot of boiling water left for to long drying up.
Answer:Evaporation
Explanation:
Why would early Earth have been toxic for modern day animals? Why were cyanobacteria able to
survive
Answer: The surface of early earth was mostly molten and volcanic. The atmosphere was hot and highly toxic.
Explanation: Photosynthetic organisms were present when earth was primarily anoxic. photosynthetic organisms were present when earth was primarily anoxic. the early forms of photosynthesis did not produce oxygen as a waste product. cyanobacteria carry out anoxic photosynthesis. the early forms of photosynthesis did produce oxygen, but it was not enough to make a difference in the atmosphere. the early forms of photosynthesis were carried out in the water, and there was no way for the oxygen to move into the atmosphere.
1
Early earth have been toxic for modern day animals as at that time atmosphere is oxygen free, and cyanobacteris is able to survive due to symbiosis.
What are cyanobacterias?
Cyanobacteria is a group of microorganisms that are related to bacteria but can perform photosynthesis. They are prokaryotic and are thought to be the earliest form of life on the planet.
Early earth atmosphere may proof toxic for modern day animals because at the earliest time, atmosphere is oxygen free means no oxygen is present in the atmosphere. And in the today scenario we can't imagine life without oxygen.
Cyanobacteria were able to suvive in that early atmosphere through alternative option like symbiosis in which a cell merges with another cell in order to the survival of both cells.
Hence life is toxic at the early time because of the absence of oxygen.
To know more about cyanobacteria, visit the below link:
https://brainly.com/question/1516890
#SPJ2
What is the difference between bulk and particle scale?
Someone please help!!
Answer:
Particle density is the volumetric mass of the solid soil. It differs from bulk density because the volume used does not include pore spaces. Particle density represents the average density of all the minerals composing the soil.
Hope that helps
What is it known as
Answer:
Some of the most incredible discoveries in science were made because the data looked wrong! Once you have the data, you may need to perform a mathematical analysis to support or refute your hypothesis. Conclusion Conclude whether to accept or reject your hypothesis. There is no right or wrong outcome to an experiment, so either result is fine.
which part of a plant conducts food and water to different part of it?
Answer:
stem is the correct answer
Explanation:
mark as me brainlist
What happens when an X-ray is shot at an atom
Answer: X-ray fluorescence from atoms occurs when a high energy particle or X-ray knocks an electron free from the innermost energy level of an atom, creating an unstable atom.
Explanation:
Several interactions can happen when an atom is exposed to an X-ray, depending on the energy of the X-ray and the properties of the atom.
The most frequent interaction is referred to as the photoelectric effect, in which an X-ray photon collides with an atom's inner-shell electron to evict it from its orbit and ionize the atom. As a result, an ion and a free electron are created. Another potential interaction is Compton scattering, in which an outer-shell electron receives some of the energy from the X-ray photon and is expelled at a different angle with less energy as a result. Additionally, pair production, which results in the formation of an electron-positron pair, can happen at very high energies. In many applications, these interactions are crucial.
To know more about high energies, here
brainly.com/question/32223681
#SPJ2
explain why the planet Venus rotates the opposite way?
Answer:
The reason why it rotates the opposite way is due to an asteroid collision forcing the planet to spin backwards and is also the reason why a day on Venus is longer then a year on Venus
___KClO3--->___KCl+___O2 I need help bro.
Constants (“controlled variables”) and a control are easily confused by students! How would you explain the difference between the two words?
Answer:
Please find the explained difference below
Explanation:
In a scientific experiment, the CONTROLLED VARIABLE, also known as CONSTANT, is the the variable that is kept unchanged by the experimenter throughout the course of the experiment. The constants are not part of the actual experiment but altering them can influence its outcome.
A control group is one of the two groups in an experiment (the other being experimental group) that doesn't receive the variable being manipulated (independent variable). The control group is the same as the experimental group except that the independent variable is unchanged in the control group. It is used to make a comparison with the experimental group.
For example, in an experiment to test the effect of sunlight on plant growth. Some plants were exposed to sunlight while some were placed in the dark. The CONTROL group of this experiment are the plants placed in the dark (no light). They didn't receive any treatment.
The constants of this experiment can be same amount of water, same type of plants used etc. This is done in order not to affect the outcome of the experiment.
Which statement about melting and boiling points is true? Question 3 options:
A. As you move down group 7A in the periodic table, the melting and boiling points of the elements decrease.
B. As you move up group 8A in the periodic table, the melting and boiling points of the elements increase
. C. Smaller atoms in group 8A require higher boiling points for the molecules to separate from each other than larger atoms in group 8A.
D. Larger atoms in group 8A require higher boiling points for the molecules to separate from each other than smaller atoms in group 8A.
Answer:
B
Explanation:
I believe it is B but I am not entirely sure! don't do this is B doesn't sound or look right to you!
Answer:
Its D
Explanation:
Larger atoms in group 8A require higher boiling points for the molecules to separate from each other than smaller atoms in group 8A.
The quantity of each type of organelle in a cell varies depending on the tasks the individual cell must perform. If a scientist needed to find cells that contained a large number of chloroplasts, where would be the best place to look?
Answer:
among plants or in a garden
Explanation:
so first thing is to establish the main function of chloroplasts which is photosynthesis the next thing is to establish which organisms primarily carry out this process which are plants therefore mostly in plant cells hope it helps
The Sun-Earth-Moon system can be modeled by using three balls. Which
statement describes a benefit of this model?
O A. It can be easily manipulated to represent changes that occur
slowly.
O B. All parts of the entire solar system can be modeled in the same
way.
O C. The model shows only how moon phases happen.
O D. The actual Sun-Earth-Moon system moves too quickly to be
studied directly.
Answer:
A. it can be easily manipulated to represent changes that occur slowly.
I need y’all helping me with this question?
Explain how you would test the presence of oxygen and hydrogen gases.
How many calories are required to convert 2 grams of ice at 0 degrees C to water vapor at 100 degrees C?
Answer:
360.8987 GRAM CALORIE OR 0.3608987 KILOCALORIE IS THE CALORIE REQUIRED TO CONVERT 2 GRAMS OF ICE AT 0 DEGREES C TO WATER VAPOUR AT 100 DEGREES C.
Explanation:
To convert 2 g of ice at 0 C to water vapor at 100 C:
First, the ice will be converted to water at 0 C
Then, water at 0 C to water vapor at 100 C
We must know that the latent heat of fusion for ice is 3.35*10^5 J/kg
the standard heat of enthalpy of water = 4200 J/kg
So therefore
Total heat to convert ice at 0 c to water vapor at 100 c is:
= M Lf + mc Q
= 2/ 1000 * 3.35 * 10^5 + 2/1000 * 4200 * (100 -0)
= 0.002 * 3.35 ^ 10^5 + 0.002 * 4200 * 100
= 0.0067 * 10 ^5 + 840
= 670 + 840
= 1510 J
The heat required to convert 2 g of ice at 0 c to water vapor at 100 C is 1510 J and to get the calorie value we divide the answer in joules by 4.184.
1510 joules = 360.8987 gram calories or 0.3608987 kilocalorie.
Amount calories are required to convert into vapor is 1,440 calories
Latent heat of water:Given that;
Amount of ice = 2 grams
Latent heat of water = 540 calorie
Find:
Amount calories are required to convert into vapor
Computation;
Heat required to melt at 0°C to water at 0°C = 2 × 80
Heat required to melt at 0°C to water at 0°C = 160 calorie
Water from 0°C to 100°C = 2 × 100
Water from 0°C to 100°C = 200 calorie
Water from 100°C to 100°C vapor = 2 × 540
Water from 100°C to 100°C vapor = 1,080 calorie
Amount calories are required to convert into vapor = 160 + 200 + 1080
Amount calories are required to convert into vapor = 1,440 calories
Find out more information about 'Latent heat'.
https://brainly.com/question/87248?referrer=searchResults
Which particles are found in an atom have charges
Answer:
protons and electrons
Explanation:
protons are positivley charged
electrons are negetively charged
but neutrons have no charge
Find the independent variable and the dependent variable :)))
Answer:
dependent variable: plant growth
independent: sunlight impact/amount of light
Explanation:
What is the best way to represent the number 1,550,000
Answer:
You can represent as a exponent. That will be the best way.
Explanation:
convert 500 inches to m.
1000mm =1m
1inch = 2.54 cm
10mm=1cm
Answer:
12.7m
Explanation:
FORMULA
for an approximate result, divide the length value by 39.370078
What is the noble gas notation For zinc
Answer:
The noble gas notation for zinc would be [Ar]3d^104s^2
Explanation:
I hope this helps you:) let me know if it does make sense, okay?
Crystal structures with ions must have ____________.a. a positive chargeb. a negative chargec. electrical neutralityd. a 2+ charge
Answer:
c. electrical neutrality.
Explanation:
A crystalline solid possesses a rigid and long-range order; its atoms, molecules, or ions occupy specific positions. The arrangement of such particles in a crystalline solid is such that the net attractive intermolecular forces are at their maximum.
Ionic crystals, particularly, have two important characteristics:
(1) They are composed of charged species.
(2) Anions and cations are generally quite different in size.
The forces holding the atoms together are electrostatic attractions. Examples of these types of crystals include NaCl, LiF, MgO, CaCO₃.
Since they are composed of anions and cations, in stoichiometric amount, they are to be said electrically neutral.
Calculate the density from the following information: A red block had a mass of 15.7 g. It was placed into a graduated cylinder containing 10.0 mL of water. The volume then rose to 17.2 mL when the block was added.
Answer:
Density should be 8.5
Explanation:
When you subtract 17.2-10.0 for water displacement you get 7.2 which is the volume and you divide it by 15.7 so your equation will be 15.7/7.2 = 8.5
Answer:
4.1
Explanation:
what type of battery still uses lead?
Answer:
Starter batteries
Explanation:
How you could use the scientific method to learn whether water really does take longer to boil if you are watching it.
Answer:
What you need is a thermometer and a clock.
Explanation: